RPM axle carrier problems...

[manbearpig616]

Does any one else have binding issues with the rpm carriers? I know i dont have the caps to tight on the pillow balls but its causing my steering to"stick" the servo cant center the wheels back up and it hums kinda loud unless i flick the steering wheel a little to center the wheels. Any suggestions? Do the carriers just need to wear in?

[Jimmie Neutron]

When is the last time you tore down the servo saver and cleaned it?

[jimbo74]

also, there are 2 adjustments..... the pillow balls into the a arms, and the pillow balls to the knuckle... either can cause binding issues if not properly setup.....

[manbearpig616]

Just had it completely torn down to dye the chassis and install thetoyz aluminum front and rear diff housings, steerng arm post, toe links and rpm carriers. If i disconnect the steering linkage there is no binding so i know its not the servo or the saver. The pillow balls are not to tight into the a arms it still has full steering range. Adjusted with a caster camber gauge and toe in toe out gauge.