It's good to be back....

[mamba max1]

Well, I've been a proud owner of my custom BL E-Revo for almost 2 years now. Lately, I've gotten into R/C planes. Turns out, planes are a lot of fun too! Sadly, my E-Revo saw no use in the past 3-4 months!


Well, I drove it today......so much fun. Only problem, my Ace DS1015 servo went bad on me?

Oh, well, got a replacement with almost identical specs for $80 less on the way now. The ace servo will be off to the manufacture tomorrow. grrr


Here's the link to my pride and joy.

http://traxxas.com/forums/showthread...=1#post4563563

[anr2442]

Whats the replacement servo? Another ace model?

Im looking for a better servo since im still on the stock two.

[Brewers74]

I've seen this truck before looking ay old threads when I joined SWEET was the first response I actually said it out loud..lol I got the SPECTRUM servo for $85 its holding up well

[BL-Bob]

Welcome back MM1. It's good to see you again!

[mamba max1]

Whats the replacement servo? Another ace model?

Im looking for a better servo since im still on the stock two.

I bought the HK15298B High Voltage Coreless Digital MG/BB Servo 66g / 20kg / 0.16s (USA Warehouse). They are actually in the USA wharehouse.....get one while you can!

[raqumup]

any chace you can tell me what parts you used to make your rear brace?

[motakitty]

I just made a brace similar to his all you need is a link and you have to make a plate to mount to the shocks. I happened to have a link from my axial ax10 kit and ends. I would say just measure it or bring it down to your lhs and have them find you a link.

Sent from my DROIDX using Tapatalk

[j.f.s]

EDIT: Sorry for going OT in your thread mamba max1

For the plate you can use the Revo brake disc hub kit TRA5565X. You only need to drill the center hole. This was my setup before I got the Tekno sways:

[motakitty]

Heres my brace

Sent from my DROIDX using Tapatalk