What Did You Do to Your EREVO Today?

[anr2442]

Since seeing this thread in other sections I decided we needed this.

I installed my capacitor bank into my wiring after seeing the Castle Cap Pack floating around. I figured even if I run 4s its still worth something since I am geared so high. I have decent batteries but they do come out warm (110*F) if i drive it really hard.

I also rechecked my tires. The 3.2 badlands on rulux wheels are still intact but have seen better days for sure. The rear 3.8 badlands on Geodes are still holding very well. I love the 3.8 badlands and will likely use this tire until the day i die.

So I was able to run the mess out of it before it rained and then about an inch came down.

[anr2442]

Feel free to add, as there is no right answer...

Its meant to be a continual thread.

[memphis2857]

Lets see 20 or 30 backflips off the fence. Broke a roll pin in the wheel hex. Re mounted ESC. Changed shock oil to 60wt. Then I went to the local track and whipped up on the slashes for a while.

[Brewers74]

Placed a order for some Proline blockade tires set of dish wheels few different set of springs, vdk shock kit, p3 rockers cant wait till Saturday will be experimenting with these items weather is expected to be really nice to do some racing at the local track

[limited60]

Placed a order for some Proline blockade tires set of dish wheels few different set of springs, vdk shock kit, p3 rockers cant wait till Saturday will be experimenting with these items weather is expected to be really nice to do some racing at the local track

What do the P3 rockers do? So you need to change anything else out to make these work properly?

I took apart my entire back end, cleaned every screw with WD40, cleaned off all the sealed bearing units, washed out tires, and rims, made it all shiny again.

Pulled out shocks, cleaned them up.

Tonight, the same will be done with the front end, then I will rebuild the shocks.

Pink and purple springs, with 70wt oil. Might be too stiff, but, we'll see.

[Brewers74]

[QUOTE=limited60;5042759]What do the P3 rockers do? So you need to change anything else out to make these work properly?
Not for certain yet just put them on I already had the black push rods that it says to use with the p3 rockers I put the stiffer blue springs that I had in the rear that made a great difference ill change them to purple onece they arrive Saturday also have 60 w oil which I'm not gonna use till the vdk gets here see sense in tearing the shocks apart twice ill be using the blue springs in the front and purple in the rear with the adjustments on the shocks 2/3 tightened but I'm setting mine up for high jumps and in hopes of not slamming the chassis so hard when landing

[bbmfkp]

I thought about putting the p3's on.

[fuzion]

i put out the big fire that the esc started.... i saved the car fortunately... ooh you chinese esc's!

[BL-Bob]

i put out the big fire that the esc started.... i saved the car fortunately... ooh you chinese esc's!

What were you doing with that tiny spur on? Tiny tires? Low kv? High amps?

[Brewers74]

Dang man you got any pics did it melt your body shell

[motakitty]

Just got my brushless erevo yesterday got my lipos today and have the traxxas cvds and center shafts on their way along with the wheely bar but so far I'm liking it.i tested it out today on 4s lipo and it's plenty fast for me and it brakes good too

Sent from my DROIDX using Tapatalk

[fuzion]

i have pics yes i will post..

edit: the body is fine. only black on bottom. i reacted really quick while wishing not to be the batteries!

[ssanderson1]

Cleaned and taped new Trenchers. New foams came today too... I'll get them mounted up on 8-spokes asap.

[Foxprogt]

I looked at it sitting on my counter top wishing the snow had stuck around alittle longer

[Mudweiser]

Mine is contently sittin on the shelf...fighting depression with the rest of the fleet. My ADD kicks in and i ignore them for months at a time while im building another one lol

[lukescb7]

Stripped the motor mount.....

[fuzion]

[Brewers74]

Oh man you wasn't kidding that looks bad your lucky the whole thing didn't go up in flames

[bbmfkp]

Are the black push rods longer?

[Brewers74]

Yes not by much tho I just bought them because mine were all beat up in the front

[anr2442]

I thought about putting the p3's on.

Yep the black pushrods are about a half inch longer than the p2 silver rods.

Try the p3 rockers. They make the truck feel much tighter like a firm sway bar setup or a racing truggy.

They are recommended onroad. Likely bc they provide that tight street feel without using sway bars. IMPO stiff sway bars and p2 setup is very similar to a p3 setup without sway bars.

[Ray00Ray]

I set my voltage on my CC BEC to 6.5V... and replaced a stock servo horn... Testing tomorrow on the beach!

[candy76man]

I pulled my daughter around in her radio flyer for about ten minutes..slowly of course Then I tried to outrun my dog (who goes nuts when he sees a rc) but was mostly unsuccessful until he started tiring out...and then I broke one of the 1x4 legs in two on my ramp, that sucked but I've been wanting to build a new one anyway.

[MiamizFinest]

I opened the closet today, saw it and closed the door. LOL

[Summit Love]

I opened the closet today, saw it and closed the door. LOL

Set it free... revos don't like to be in closet. I Feel sorry for your revo and I hope you don't buy a summit. I would have to rescue that summit if you did.

[Imprez]

Drove mine last night in a few inches of fresh snow with the LEDs I've recently installed, it was a total blast !!!
I taped it all on my GoPro but... it was 1:30am so it was way too dark for the GoPro... you hear the ERBE blasting around and you see the headlights and tail-lights but other than that you don't see squat !!! lollll

Oh well, better luck next time !!!

[nev_neo]

Drove mine in the local park today.. 5s is pretty good !
Also had a pack of dogs chase it all over the hills and down again.. lol
Their owners thanked me for giving them the exercise.

[Chimbo2]

Just purchased it yyyyeeeeeeeesssssss ssssiiiirrrrrr!!!!

[anr2442]

Tore down the rear and added a "fix" to stop diff from moving. What a boring day.

[Brewers74]

Spent two hours wrapping the pivot ball retainers hopefully this will stop them from backing out hour later changing shock oil and springs ran for three hours had two cheap ******* batteries fail me SPC are still going strong

[anr2442]

Spent two hours wrapping the pivot ball retainers hopefully this will stop them from backing out hour later changing shock oil and springs ran for three hours had two cheap ******* batteries fail me SPC are still going strong

What ******* batts where they?

[Brewers74]

What ******* batts where they?

They are some elcheapo ones think $30 apiece from LHS used them in the Stampede which they were fine in it but now it sets (wanna buy it...lol)
5000 20c 2 cell not ideal for the erbe

[motakitty]

Took mine out to a dirt feild and realized I needed stiffer springs and more steering so I put the silver springs in back and gold in front and put the max steering throw in so ill see how this setup works

Sent from my DROIDX using Tapatalk

[muck]

finished soldering elects and bad, tuned steering, and installed better springs and shock oil..

ran it around the yard letting the dog to chaise it..

[candy76man]

finished soldering elects and bad, tuned steering, and installed better springs and shock oil..

ran it around the yard letting the dog to chaise it..

Does your dog try to rip the tires apart when he catches it? My dog is neurotic about rc's, if he sees or hears one he will literally go insane...and he can just about keep up with my revo running 40mph for the first few minutes anyway...he always catches it when I have to slow down for a turn...he'll grab a tire, while it's still going 15 mph, flip it over and start chewing on a tire until I yell at him.

[muck]

Does your dog try to rip the tires apart when he catches it? My dog is neurotic about rc's, if he sees or hears one he will literally go insane...and he can just about keep up with my revo running 40mph for the first few minutes anyway...he always catches it when I have to slow down for a turn.

Yes he does.. I'm all ways having to get after him to stop trying to shake it.. I drive slower than normal with mine since i do not want to hurt mine.. He barks and barks while i'm trying to get the lid on LOL

[FullyCharged]

TodaynI knocked another cvd out of the drive cup again....so annoying when that happens...

[Brewers74]

Yeah got a sweet delivery today

[memphis2857]

Repaired another broken axle! Painted and installed my new body.

[Chimbo2]

That's elegant right there