Rookie needs help

[pooochie]

I just converted my slash to a merv and in the process replaced all of the axle carriers and bearings in them. I also replaced the drive shafts. My problem is that I can't run low throttle and when taking off it lags. It is a vxl and the drivetrain seems stiff. I have replaced the transmission bearings in the past so im wondering if it is the differentials and what could be wrong.

[corey52587]

Did you check your gear mesh on the pinion an spur gear?

[pooochie]

I did but my spur gear is pretty worn out. Even with the motor out the drivetrain is still stiff. I am completely mystified. It must be the differential. Is there a way to grease/change bearings in the differential.

[Jimdog]

I took my slash through water and let it sit when i was done. Next morning half the bearings were frozen. To fix this I took the bearings out,Removed the seals, put them in an old pill bottle and shook them in WD-40 to clean them out then I just put grease in them with my finger, then put the seals back on. It took some time but it worked almost perfectly for me. (It was also somewhat messy).

[corey52587]

Yea just take ur bulkheads out an the diff will come out you can replace the bearings if u dont want to clean them

[pooochie]

Thanks guys