Custom 1/16 Revo w/ Upgrades ARTR, Revo 3.3 Brushless Coversion Roller & More!

[KeltiKrewser]

I'm Looking to get a new Rc and need to make some room/money so I can get it. I will post more pics later tonight.

Here's what I've got:
Custom Mini Revo with custom Big Block and upgrades ARTR. $300 shipped
OG box with Manuals and Exploded views
4000 KV 550 Brushless motor
100 Amp Esc with programming card
3Racing motor heatsink with fan
Custom made Motor plate and Mount
Rpm Arms all around
Gpm Hubs all around
Gpm Shocks Front and Rear
Steel Hollow balls
RC Screws Stainless Screw set
Custom Rear Chassis Brace
Rocker Bearings
Titanium Pillow balls and Hinge Pins on front arms
HR rear skid with wheelie bar
Integy Front Skid
Chassis, Rockers, and Push & Tierods all dyed black

Additional items included:
3 bodies Stock, Proline Baja Bug, and Custom Buggy Body
2 sets of Wheels and Tires
-Imex 2.8" Dish Wheels with Imex Paddles
-Imex 2.8" Chrome Romulin Wheels with Imex H-Square Tires
Spare Parts
-Axles
-Springs
-Shocks
-Steering Assembly
-Full set of Stock Arms
-2 Front Body mounts(one new, one modified for Baja/Buggy bodies)
-Tall rear body posts (for Summit bodies)
-used rear Bulkhead
-2 used front skids
-New in Package 55t Spur gear

Buggy Body with Paddles


Baja Body with H-Squares

This currently has an Airtronics 92524(compatible with most Airtronics 2.4 systems) rx in it, and can be included for $25, otherwise I have the stock AM TX/RX I will throw in, the RX needs a new antenna wire.

HERE is a link to my build thread of the Chassis. After completing it I swapped the chassis into my Merv

Revo 3.3 with Brushless Conversion Roller $200 shipped
I just did the conversion on this, see the build HERE
Trans locked in 2nd with FOC
Roller will include everything but the electronics & batteries. It has an Airtronics 92624 rx I will include for $25 if you want it. Compatible with most Airtronics 2.4 systems

40 Series Wheels & Tires with 23mm Hubs
Rpm Front arms
Polished Stock Chassis
Slash front Bumper


Revo 3.3 Parts Available (can package deal any or all with Roller if you want)
Complete 3.3 engine(Air filter to Muffler) with EZ-Start & Wand $100
Engine Ran Great when I pulled it for the conversion. Approx. 1 gal of 30% thru it, ALWAYS had proper after run maintenance

Complete Trans with Reverse and Opti-Drive & Controller only 1 Run on this $40
New Center Diff Kit w/FOC $30
1 Stock Steering Servo $15
Throttle Servo $15
Reverse Servo $10
Opti Drive Controller $10
Fuel Tank $10
Throttle/Rev Servo Box $10
RX Battery and Charger $ 15
RX/Opti Box $10
Super Hot Shot2 Glow ignitor w/Charger $10
3 Stock Wheels/tires, rims are a little beat up, but good tread, 1 stock rim w/o tire $20

I also have some Proline Body post and random trans parts from converting the trans for brushless I will throw in with anything else.

Traxxas Rally body With Custom Paint, Never Run on car $40
I also have the complete sticker sheet minus the stuff thats on the body




All prices are obo and include Shipping to US, Paypal only. And like I said I will do package pricing on what ever you want. This is my first time selling here but I have good feedback over on TheToyz Forums under the same username SEE IT HERE

Thanks for looking,
Ryan

[brianwlkr]

bump nice stuff

[KeltiKrewser]

Thank you!

Here are some more pics. If there is anything specific you would like to see, let me know and I'll try to get it posted asap. Shoot me some offers, any reasonable offer will be entertained, I really want this stuff gone.























Thanks,
Ryan

[KeltiKrewser]

More pics that wouldn't fit on last post.













Thanks,
Ryan

[Skitlerz]

i cant belive your selling that Merv! i was loving watching you build it!

[ajp12790]

how fast is the 1 16 e revo and the revo 3.3 electric conversion

[KeltiKrewser]

i cant belive your selling that Merv! i was loving watching you build it!

Thanks! it was alot of fun building it. I'd love to keep it but I just don't drive it that much and I'd rather it went to someone who will use and enjoy it. you have a pm btw.

how fast is the 1 16 e revo and the revo 3.3 electric conversion

I don't have any "clocked speed" on either of them, but I can tell you they are both FAST with tons of power. The Mini requires pretty conservative throttle control to keep it off the lid and can do standing flips on 2s with ease. The 3.3 can pull the wheels off the ground at will and leaves my buddy's T-maxx 3.3 in the dust.

I can give you some theoretical speeds based off of the gearing,motors,batteries and tires I run.

On the Mini I run 33/50 gearing on 2s with a 4000kv motor and 3.8" tall tires, the theoretical top speed(TTS) is 49+ mph and I would say that is a fair estimate. The motor has never hit over 140*F and the ESC has never been over 100*F. If you bumped up to a 3s Lipo TTS would be almost 75mph with the same gearing. With the highest gearing you could run on this car, 35/43, the TTS would be over 90!

On the 3.3 I run 20/38 with 5.8" tires and a 2000kv motor on 4s. The trans is locked into 2nd gear with the std ratio gear set. TTS with this set up is 46+ mph and again I would go along with that. The motor in this has never even hit 100*F and I have yet to install a heatsink, the ESC stays around 60*F. The Esc/motor combo will take up to 6s, if you did that with this setup TTS would be 70mph. If you ran the highest gearing possible 25/34, installed a Wide range 2nd gear and stock size 6.3" tires on 6s TTS would be 115+mph.

Please keep in mind these are all THEORETICAL speeds, I am in no way stating that these cars can or will survive these speeds! But as far as the speeds estimated with the current setup I will say they are very close to those.

I calculated all speeds using THIS

Thanks,
Ryan

[KeltiKrewser]

Bump. Make some offers. Prices are flexible and I want this stuff gone.

[KeltiKrewser]

to the top please

[ajp12790]

what comes with the mini e revo? is it RTR?

[KeltiKrewser]

The Mini Revo is almost RTR. All you will need are batteries and a Radio. I can include a stock TQ Tx/Rx but the rx needs a new antenna, or I can include the Airtronics RX that is in it now. The model # of the rx is 92524 it is compatible with all Airtronics FHSS-2 surface Transmitters including MX-Sport, M11X, MT-4, MX-3X.

Other than that it's ready to go! Shocks and Diffs were gone thru when I did the swap with my Rally, and I've driven it twice since then so everything should be in tip top shape.

[ajp12790]

ok thankyou

[KeltiKrewser]

On a side note, You could also trade in the TQ radio and receiver I'm including and upgrade to the Traxxas Link for $62.50 @ your local traxxas dealer or online. Not bad for a 2.4 system.

[ajp12790]

ok thankyou

[KeltiKrewser]

PRICE DROP!!!
Mini Revo $275 Shipped
Revo Roller $175 Shipped
Complete Revo 3.3 Package (including all parts off of/for Revo 3.3) $450 shipped


Here are a couple more pics of the Revo 3.3 Roller as it will come to you.







I am motivated to sell these so prices are flexible. Shoot me a reasonable offer and they will be yours.

Thanks for looking,
Ryan

[KeltiKrewser]

Package Price: Both Trucks, Nitro Engine & All the Parts $550 w/split shipping.

[KeltiKrewser]

Merv + Parts $250
Revo + Parts $400

Offers??

[KeltiKrewser]

Midnight bump

[KeltiKrewser]

Thinking about changing the Merv back to a stock chassis, with the stock VXL motor & Esc. Any interest in that?

Also possibly putting the 3.3 back to stock nitro setup.

Let me know.

[c.greer]

Pm sent.....

[KeltiKrewser]

C.Greer, Back @ ya

[KeltiKrewser]

Bump

[efarrell]

Sent you a pm

[KeltiKrewser]

Sent you a pm

Replied...

[KeltiKrewser]

To the top Please.

[KeltiKrewser]

up!

[KeltiKrewser]

Sale pending on 3.3, trans and Revo parts.

Both Trucks still available.

[KeltiKrewser]

Deal pending on Revo Roller.

Merv Still Available, should have updated pics tomorrow night.

[trapdrew]

how much for evrything for the reverse kit 30.

[KeltiKrewser]

The Trans and all the links and servos are gone. Sorry

[KeltiKrewser]

Trade pending on Revo Roller.

[KeltiKrewser]

Revo Roller, and all Nitro related parts are sold.

Mini Revo and Rally body still available. Merv is back onto stock chassis w/stock electronics. I will post updated pics asap.

Thanks,
Ryan