+ Reply to Thread
Results 1 to 3 of 3
  1. 09-04-2011 11:49 AM #1
    paintballa95
    paintballa95 is offline
    RC poster
    Join Date
    Jul 2011
    Posts
    9

    How do I remove driveshaft?!

    I have a 1/10 erevo mamba monster and I broke a rear driveshaft. How do i remove the blue hex hub? Does it pop right off or do I have to screw it off like I did for the wheel?
    Reply With Quote Reply With Quote
  2. 09-04-2011 12:44 PM #2
    87 GN
    87 GN is offline
    RC Turnbuckle Jr. 87 GN's Avatar
    Join Date
    Mar 2010
    Location
    kansas
    Posts
    6,283
    Take the set pin out #5189 then it should slide off. Some times I have to use a hammer & small punch. The set pin will work in the stub axel hole & make a small bur. If the stub will not slide past the bearing, take a fine file or sand paper & smooth up the stub axel around the hole.
    Last edited by 87 GN; 09-04-2011 at 12:50 PM.
    Would you go flip my truck back over??
    Reply With Quote Reply With Quote
  3. 09-04-2011 05:21 PM #3
    paintballa95
    paintballa95 is offline
    RC poster
    Join Date
    Jul 2011
    Posts
    9
    Wow thanks! It helped a lot.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules