So I have the new ERBE running with the stock NiMH batteries to get the hang of it, got a good charger and its running fine BUT when I get LiPos for it, how do I set the ESC for the new LiPo batteries? The owners manual that was in the box is for the 5603 model that has a completely different motor/ESC combo.In the single page note thats has STOP at the top it says to reset the Mamba Monster to the correct LiPo cutoff voltage prior to running LiPos. I did NOT get a Mamba Monster manual. Do I just plug in LiPos and go run it? There is a switch on the fan cooled ESC that I turn on to start the truck and start the system after I turn on the hand held transmitter(radio). The actual owners manual has completely different pictures and operating instructions for the "Castle Creations Monster mamba" that came out of the box. Is there a 5608 manual? The pictures and everything I have here is all wrong. The only thing I have to read is a one page black and white sheet with some instructions but its not enough info. For what I spent on this rig, it should have the correct manual? Do I have the wrong manual?