Results 1 to 7 of 7
  1. #1
    RC Racer
    Join Date
    Aug 2005
    Location
    Athens GREECE
    Posts
    105

    Aluminum Slipper pads

    http://cgi.ebay.com/Slash-4x4-Alumin...item4aa9e25f5f

    I checked behind my spur and saw that one of the 3 pads was broken in half.

    And then i saw these and i was wondering if the will fit the 2wd slash , I thing they will hold out better than the stock ones.

    So are the pads of the revo same size as of the slash 2wd , Its looks like they are.

    also there are these from different material http://cgi.ebay.com/ws/eBayISAPI.dll...=STRK:MEWAX:IT


    and these longer ones with more surface. http://cgi.ebay.com/ws/eBayISAPI.dll...=STRK:MEWAX:IT

    what do you think ? will the normal or the longer ones fit the stock 2wd slipper ? i wish they are because i will be running an 1:8 big motor
    Last edited by Andreas_BL; 04-02-2011 at 09:56 AM.
    Master of Greek bashing

  2. #2
    RC Champion
    Join Date
    Oct 2009
    Location
    Germany
    Posts
    1,552
    All of those will fit.

  3. #3
    RC Qualifier
    Join Date
    Feb 2011
    Location
    SE Wisconsin
    Posts
    295
    I'm interested in this too. What are the pros/cons of aluminum or graphite pads vs. rubber?

  4. #4
    RC Racer
    Join Date
    Aug 2005
    Location
    Athens GREECE
    Posts
    105
    yeap , that's one of the reasons i started this thread !! any thoughts ?
    Master of Greek bashing

  5. #5
    RC Champion
    Join Date
    Oct 2009
    Location
    Germany
    Posts
    1,552
    The aluminium ones don't wear as fast and are more resistant to heat. This is important in an E-Revo for example, and likely with a high power 1:8 motor like this too.. the stock motor or standard 1:10 BL sets shouldn't make them necessary.

  6. #6
    RC Qualifier
    Join Date
    Feb 2011
    Location
    SE Wisconsin
    Posts
    295
    Ok thanx fot the reply but what about the graphite ones?

  7. #7
    RC Champion
    Join Date
    Oct 2009
    Location
    Germany
    Posts
    1,552
    I never used the graphite ones, so I can't tell you anything about them. I use the large aluminium ones on my ERBE and the small ones on my Slash.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •