I have trouble when i race my 4-tec because my pinion gear keeps coming off. i run a trinity p2k if any one could help please do!
------------------
Jared
+ Reply to Thread
Results 1 to 8 of 8
Thread: Pinion trouble
-
02-20-2001 05:24 PM #1Bambo87Guest
Pinion trouble
-
02-20-2001 05:29 PM #2bobbyGuest
are u sure u put it in right?
is the grub screw on the flat side of the motor shaft? make sure it is and tighten it. this should keep it on .
hope i helped
-
02-20-2001 05:33 PM #3Bambo87Guest
that is the way i run it but it doesnt work just falls off again
-
02-20-2001 05:38 PM #4RC Enthusiast
- Join Date
- Jan 2001
- Location
- decatur
- Posts
- 28
u yea
-
02-21-2001 08:58 AM #5RC Champion
- Join Date
- Jan 2001
- Location
- England
- Posts
- 1,354
tighten up your grub screw !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!
are you thick or somthing?
-
02-21-2001 03:44 PM #6Bambo87Guest
it is as tight as it goes
-
02-21-2001 05:04 PM #7RC Racer
- Join Date
- Jan 2001
- Location
- Mercer, PA, USA
- Posts
- 168
Tell us some more information and we might be able to help you some more.
------------------
-Zee
-
02-22-2001 03:29 PM #8RC Enthusiast
- Join Date
- Jan 2001
- Location
- Florida, Gauteng, South Africa
- Posts
- 42
If your grub screw's allen key head is stirpped, you might have to resort to what I do: Put a drop of superglue on there!! You won't be able to change pinions in a hurry, but it keeps the pinion in place, and when you want to remove the motor, a light tap or two on the drive shaft works to free the pinion again. If you wanna go that route...
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts