2.4 steering just stopped working...
I have a rusty vxl with the 2.4 GHz Link system. I was doing some cleaning, so I removed the servo wire and the esc wire from the reciever. When I replaced the wires I accidently plugged the esc wire into the wrong channel. The ecs then went crazy and turned the motor on full speed without me touching the transmitter. The only way that I could stop it was to pull the battery. After I stopped it I plugged it back into the correct channel and the esc worked fine but the steering will not work now. ????? It doesnt seem like that could have caused the problem though. Could it have been caused by removing the wires in the first place or did I short something out?