Results 1 to 3 of 3
  1. #1
    RC Champion
    Join Date
    Dec 2004
    Location
    Places
    Posts
    1,751

    Center driveshaft: Hollow, but is the pattern continuous?

    Hey guys,

    Quick question. Is the internal "star" pattern of the 4x4 center driveshaft constant throughout the entire driveshaft? I know the driveshaft is hollow, but is the internal design consitant through and through? For example, if I am to cut the driveshaft in half, would the "star" pattern still be there?

    This is for a concept project involving an extended chassis with two center driveshafts, but one of them would have to be cut a few inches shorter.

    Thanks
    Last edited by moneybagsfor-rc; 06-09-2010 at 10:49 PM.
    therczone.com/forums/showthread.php?t=7380

  2. #2
    RC Enthusiast
    Join Date
    May 2010
    Location
    amsterdam,ny
    Posts
    40
    Yes the spline runs all the way through the shaft.

  3. #3
    RC Champion
    Join Date
    Dec 2004
    Location
    Places
    Posts
    1,751
    thank you!
    therczone.com/forums/showthread.php?t=7380

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •