rustler parts fit

[jman98]

Hey guys,
my truck was in the shop because I broke a rear suspension arm and the lhs just called me to tell me he fixed it with the rustler suspension arm!! So those fit and they are from the rustler.

[Mr. eXtreme]

I think the shock mounts are a little differant though... So you will lose travel in the suspension

[bbecker]

We NEED RPM parts !!!!!!!!!!

[Orgnoi1]

Hey guys,
my truck was in the shop because I broke a rear suspension arm and the lhs just called me to tell me he fixed it with the rustler suspension arm!! So those fit and they are from the rustler.

thats cool... I hope its correct... the part numbers are almost the same... Rustler Rear A-Arm is a 3655 and the 4x4 is a 3655X...

[asheck]

Parts noted with an x, are interchangeable with the ones that aren't. There are just slight differences. In this case it is the extra shock mounts.

[Mr. eXtreme]

We NEED RPM parts !!!!!!!!!!

I emailed RPM awhile back asking if the 2WD parts would work. They said until they got one they couldn't be sure. But now that the trucks are out I'm sure there at work on it!!

[egmuni]

It will work for the front arm too...with a little modification. Today, that's what the owner of my LHS did for me. I broke the right front arm and for a temporary fix, he used part # 3655 and dremled out the cross brace arm and I was back at the track in no time. I had just stopped in the shop to ask when he thought spare parts were going to be shipping and to my surprise...he went out of his way to get me back up and running! That's why I like dealing locally!

[Orgnoi1]

We NEED RPM parts !!!!!!!!!!

If a 3655 works... then so would its RPM replacement

[bbecker]

Looked at the other thread.. where someone actually did this.

Here is the RPM part that will kinda work - 80182 (Black) and 80185 (Blue)

http://monster.traxxas.com/showthrea...ht=Rustler+ARM

[Orgnoi1]

I will be putting them on tomorrow... just HAPPENED to buy a used slash today and the guy gave me two sets of 80182... I was like "what tha" on the way home... then realized I had just spec'd out the part numbers and these SHOULD work...

[Randopolis]

You're going to have to dremel to get those RPM arms to work. They're much fatter on the ends than the stock ones. Works good though once you get it done.

[jman98]

it was the a-arm and the only differrence was a small hole for a sway bar so it works and took it out off road and it did good. =)

[cyclone215]

Any other parts fit the 4X4 from 2wd ???

No telling WHEN the 4X4 parts shipment will show up