Grave Robber on an ERBE

[TitusTetricus]

I see a few people who have talked about using this body on their ERBE, but I don't see anyone saying if they actually did it, and what body posts they used to do it.

Has anyone done this yet, and if so, what posts, and where did you put the holes?

I lined up the body on a Revo 3.3, it was all that was handy, and it looks like the stock location for the mounts will mean holes need to go through the back of the body, which would look really awkward.

The only other thing I can think of is to get some REALLY long posts, heat them up, and then bend them so they'll get closer to the spot where they marked for the holes to be drilled.

Any suggestions?

[Brushless Moose]

Any suggestions?

call it the correct name LOL. Grave Digger.

[TitusTetricus]

I am calling it the right name, Grave Robber is a hearse body from HPI. http://www.hpiracing.com/products/en/7167/

[MoonDeville]

Ya know. I want one of these too. I bet it would fit fine but only if ya took off the Revo front bumper. Or you could do some dremel work on the rear of the body.

Moon

[piledriver]

little quick there wasnt ya Moose haha

[Hughes500Bob]

You can use Summit posts (#5616) for more length. You could saw the tops off of your set and bolt new posts using two bolts in each upright's adjusting holes ... "inboard" to shorten the distance between them if necessary for fit.