so i picked up a .18tz w/11k carb, came with the header, the back plate, have a look @ the pictures !!! 40 $$$ CDN i got it for !!!
so there must be a reason i got this for 40 bucks . .what am i looking for to see if this is a good mill ?
is the motor supposed to turn both ways ? is that not a one way bearing on the shaft side ?
its hard to turn over and pops as its coming around TDC
what am i looking for inside when i take the head off . .
can i check the carb somehow ?
My 3.3 is still running strong, on my third gallon + whatever the guy before me ran through it
i see the HSN LSN and idle, whats the fourth screw on the side of the carb ?
should i rebuild it and send it off to AB Mods ?
any help or advice on my cheap mill would be appreciated
as well that looks like the wrong ball end ling for the throttle? its on there tight though ????