I'm thinking about putting two 3.3 engines in a Villain hull, and would like some pointers on how to do it. I figure I will use two pickups for water cooling, and run copper tubing between the fins of the cooling heads. Also I want to have the exhaust coming out of the back, one on the right and one on the left, because I think that would look extremely cool. I also want to use brass props since they also look extremely cool. Could the upper deck be converted to an enclosed style like the new Blast? That looks extremely cool, and I'd like my Villain to look like that. I know the penguin gears aren't too strong since the stock Titans strip them out with like 1200 mah 6-cell nicds. Does anyone know where I could get titanium gears made? Or at least stainless steel? I think titanium looks extremely cool, and I don't want them rusting up. I also want to be able to remotely adjust the trim, so I'll probably go with a 4-channel radio. I'm thinking about using the new TQ4 that's coming out, that way I can use that switch that the Summit uses for locking diffs, for setting my trim. Also I want to fit a return-to-shore system, so I'll probably use the red channel 3 switch to switch on the motor. I don't like waiting, so I'm going to use the EVX-2 Marine on dual 2S LiPo batteries with the marine Titan motors, and they'll have their own water pickups for cooling. That way when I kick in the return-to-shore, I can have my boat back in about 10 seconds or so. Because I don't like waiting.
Ok guys, help me out here I'm a newb and I'm not sure how to do this properly.