I want to do this to my E-revo, need help.

[dr.bjm]

I want to convert my E-revo to a CORR style with the SC8 body like this one in the link. Can you tell me what part #'s I need to complete it?
http://cgi.ebay.com/Brushless-Traxxa...3A1%7C294%3A50

[e revo maniac]

basically all you need is smaller wheels slayer and slash size 2.2 and the slayer a arms and a sc8 body

[EREVO2121]

thats sick! too mass money holmes!!

[asheck]

You basically need Slayer arms,and suspension rods,I would look on ebay http://cgi.ebay.com/Traxxas-Slayer-T...1%7C240%3A1318 .Then your 17mm hubs,wheels tires and body.Honestly if you can't find the part #'s,it's to much project

[dr.bjm]

LOL, not only am I lazy I am stuck in the office hiding this forum from "The Man."

[31794ty]

Isn't that a little to much truck for that motor?

[RustlerRacer16]

Wow...that thing is amazing. If it had the bumpers it would be complete. I may have to do that to mine...

[MXrider]

Isn't that a little to much truck for that motor?

Might be, but to be honest I think the smaller wheels probably make it run better than an E-Revo with a VXL.

Anyway, it looks great but I would never do it. The body would get thrashed without bumpers, and you'd be breaking parts left and right. Bumpers are pretty key to the CORR RC trucks, IMO. Though I think the rear Slayer bumper will fit.

[RustlerRacer16]

I think the rear Slayer bumper will fit.

It will! It would look sooo great!

[J.A.T.O.3.3]

I belive both the front and rear bumpers of the Slayer will fit the E REVO as it uses the same body/bumper mounts ....

[MXrider]

I belive both the front and rear bumpers of the Slayer will fit the E REVO as it uses the same body/bumper mounts ....

Well it will but from what I have seen the front bumper is not compatible with the SC8 body. I haven't seen it but my guess is that the Slayer Bumper comes up to high for the low body.

[Brushless Moose]

I am sure with dedication you could get both motors to mount. where there is a will, there is a way, i.e, blowtorch!

[erevo450r]

what would you suggest would be the best motor setup/ gearing for this conversion?

[DanZman]

I'd say use the MMM combo and gear 40 to start, then depending on temps go from there

[erevo450r]

do you think the velenion would work with that gearing as well

[Brushless Moose]

no, i would not try and gear the VXL for 40, as it will get too hot. start with like 14/68 and work your way up, until you reach like 160F on motor, then drop one tooth off of the pinion.