Half Shaft and its mysterious U-joint question
I have to buy and mount one of this http://www3.towerhobbies.com/cgi-bin...&I=LXHFY1&P=OW but I really can't imagine how to unmount the U-joint with the cubic iron attached. For the small one it's enough to untoggle the E-clip, trivial joke, but the bigger one has nothing to use but itself.
Which is the way to unmount it on older one to use it on the new half shaft ?
Thanks in advance
Step 1: Pull out the smaller, thinner pin that is held by the e-clips.
Step 2: Just push out the bigger pin that goes through the cube with a screwdriver or anything. It's only held by the thinner pin that gets put through it (and the cube) that you pulled out in step 1.
It was hard indeed but it worked.