Last edited by Double G; 07-23-2014 at 04:46 PM.
My slayer pro and slayer pro tool box
Here we go
Started with the stock slayer... New engine (Bad Crash) engine roll cage, sway bars, pipe and air filter Tires, 2.8 trenchers on desperado wheels and Boom My Murda Slayer! Hope You Guys Dig it... more upgrades to come
Last edited by Jakeb; 07-13-2013 at 12:38 PM.
A few more pics. For some reason I couldn't add them to my other post a few spots up, but here ya go
Ditched the ez start went the glow igniter and pull start route
also upgraded the push rods and toe links
don't know whats next.... created a monster
Now time to put some scratches on it!! Chevy runs deep!!
Last edited by slimwhitman; 10-12-2013 at 10:20 AM.
Last edited by Double G; 07-16-2014 at 08:22 AM.
My new fav! Short chassis 3.3(for now) mods: tekno rx/battery/fuel tank kit, tekno throttle servo mount, losi 8b fuel tank, OFNA 053 side pipe, Slayden steering mod, 100k diff fluid front and locked rear, Teflon GTRs w/3.8 rate front and 3.5 rear, Tigerdrive starter, 2075 servos, modded 12mm aluminum hex drives, Proline pre-mounted Trencher SC, T-maxx 3.3 body(for now). Soon to buy: nerf bars, sway bar kit, modded revo axles, aluminum rocker arm posts pivot balls toe links and push rods. Built from a couple part lots and eBay
Revo P26 T-Maxx P26RD T-Maxx TRX3.3 Slayer TRX3.3
Last edited by dyabinho; 06-22-2014 at 12:17 PM.
This is my mud setup of slayer pro 4x4. 17mm hex hubs and Pro-Line's Masher 3.8" on Desperado black 1/2" offset wheels.