Results 1 to 2 of 2
  1. #1
    RC Competitor
    Join Date
    Jun 2008
    Posts
    69

    RPM gear cover doesn't fit :(

    Running in the mud and I got a lot of crud up in the gears. I bought the RPM cover so I could fully seal the pinion/spur area. Doesn't fit though. The stock cover it very thin at the base. This is required as the rear bumber mount comes forward ever so slightly. Since the RPM cover rises from the base, this mount pushes the rpm cover a little bit forward causing the holes not to line up.

  2. #2
    RC poster
    Join Date
    Jan 2008
    Posts
    17
    Yeah, found that out last night too. I used a little
    Gorilla Tape to cover the cut out in the stock cover until I McGuyver up a fix on the RPM piece.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •