+ Reply to Thread
Results 1 to 6 of 6
  1. 03-13-2006 02:09 PM #1
    superwooter
    superwooter is offline
    RC Enthusiast
    Join Date
    Aug 2005
    Location
    ms
    Posts
    20
    Send a message via AIM to superwooter Send a message via Yahoo to superwooter

    transmitter/reciever problem

    i hope someone can help. i have fresh batteries in the radio and onboard the jato. when i turn the switches on, the servos respond fine to the radio. but when i start the motor, the servos start to move on their own and do not respond to the radio properly. does anyone have any ideas?
    thanks

    michael
    SILVARADO BODY / JR STERING SERVO / TIRE SETS INCLUDE: DIRT PAWS, MASHERS, & WHATEVER THE STREET TIRES ARE CALLED /
    Reply With Quote Reply With Quote
  2. 03-13-2006 05:03 PM #2
    superwooter
    superwooter is offline
    RC Enthusiast
    Join Date
    Aug 2005
    Location
    ms
    Posts
    20
    Send a message via AIM to superwooter Send a message via Yahoo to superwooter
    ANYONE???
    SILVARADO BODY / JR STERING SERVO / TIRE SETS INCLUDE: DIRT PAWS, MASHERS, & WHATEVER THE STREET TIRES ARE CALLED /
    Reply With Quote Reply With Quote
  3. 03-13-2006 06:11 PM #3
    performance1st
    performance1st is offline
    RC Competitor
    Join Date
    Mar 2006
    Location
    somewhere
    Posts
    95
    Send a message via AIM to performance1st
    maybe interference
    Avoid arguments with the Mrs. about lifting the toilet seat by simply using the sink. : If you have a bad cough, take a large dose of laxatives, then you will be afraid to cough. : If you run from a sniper you will only die tired
    Reply With Quote Reply With Quote
  4. 03-13-2006 07:05 PM #4
    Jato666
    Jato666 is offline
    RC Racer
    Join Date
    Aug 2005
    Posts
    164
    is it when the engine is running, or when you have the ez-start in the plug, so before the engine even starts? sometimes that will cause inteference. Traxxas 27mhz sucks. Id reccommend going to 75mhz with a futaba kit. its only $50 at a hobby store, and it should solve your glitching problems. I used to glitch all the time with mine, and i used to always run a fail safe just to make sure it didnt run away. Since ive had that futaba radio, I havent once used a fail safe, and Ive only experienced minor steering glitches once, but nothing that caused me not to be able to drive the truck.
    Reply With Quote Reply With Quote
  5. 03-14-2006 09:27 AM #5
    Jato_Maniac_FL
    Jato_Maniac_FL is offline
    RC Competitor
    Join Date
    Dec 2005
    Location
    Tampa, FL
    Posts
    93
    I had a similar problem and after some research I discovered I had a damaged receiver. After I replaced it, everything was fine again.
    Reply With Quote Reply With Quote
  6. 03-14-2006 12:55 PM #6
    superwooter
    superwooter is offline
    RC Enthusiast
    Join Date
    Aug 2005
    Location
    ms
    Posts
    20
    Send a message via AIM to superwooter Send a message via Yahoo to superwooter
    IF I HAD TO GUESS I'D SAY IT WAS A DAMAGED RECIEVER. IT ONLY ACTS CRAZY WHILE THE ENGINE IS RUNNING. IT RESPONDS GREAT BEFORE I CRANK UP.
    THANKS
    SILVARADO BODY / JR STERING SERVO / TIRE SETS INCLUDE: DIRT PAWS, MASHERS, & WHATEVER THE STREET TIRES ARE CALLED /
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules