I just broke rear bulkheads.
Please advice good and cheap bulkhead,i think i need aluminum.
Is this good link and not heavy then stock?
The other common link is GA http://www.greatassemblyrc.com/6061_T_6_Bulkheads.cfm
you get a front and rear with braces for $80 shipped.
ACNCM bulks are good for low cost and high strength. The GA 7075's are the best bulks out there, and the Dace Predator's are to my knowledge the lightest.
If you only broke your bulks in some freak accident, I recommend replacing it stock. If you expect to keep breaking stock, and don't want to spend a lot, go with the American CNC Machining.
thanks for replays.
What is a damage points of bulkheads, what part of bulkhaeds are brakeable mostly.
Post pics if available.
Do i need good bulkhead braces ?
What for brace is?
Depending on stress will depend on where brake point. Where I broke bulks were the extensions that attach to chassis or shock tower. This happend as I used stock bulks surrounded by all aluminum.