servo specs

[bart luther]

would this servo fit in my stampede ?Dimensions : 1.60 x 0.79 x 1.69 in.

(mm): 40.6 x 20.0 x 42.8 mm

Weight: 73 Grams / 2.58 oz.

Ball Bearings: Yes, 2BB

Metal Gears: Yes

Torque (4.8V): 103 oz.in.

Transit Time (4.8V): 0.33 sec./60°

Torque (6.0V): 119 oz.in.

Transit Time (6.0V): 0.27 sec./60° THANKS GUYS !!! what Connectors would I need j for Futaba Radios.
JR / Hitec / Airtronics "Z" radios . I have the QT radio that came with the stock pede.

[razer]

It should fit. It looks a tiny bit taller than standard servos, but you can always trim a little off the bottom of the front body mount if it's too tall.

[bart luther]

Thanks Razer !

[razer]

No prob, I didn't see the Q about the connector when I first replied but either one will work. The JR/HiTec/Z connector is basically just a Futaba connector without the extra tab on the side. Just make sure you plug it in the right way.

[NewbieStampedy]

Credit to you for your research, most people woulod have just bought it and if it didn't fit they would just go and take it back. Well Done!!!

(it should fit and it will work)

[bart luther]

This traxxas board is GREAT ! I am just starting out with hobby grade RC, so thanks for all the help .somday I will help others that are new .

[crystel]

sounds like a GWS S06 metal geared servo. If so, I have one and it works great,...... but as said before, you'll have to trim the bottom of the body mount to fit. You can do this easily with Dremel, or a similar rotary tool. Good luck!!