I got my nitro rustler...which is my first nitro car EVER! So im really excited, but seeing all those parts is kinda intimidating! I read the manual, and i have an idea how RC stuff works in general...but does anyone have some website guides on how to disassemble it when things break or for getting hop ups added on?
Also, i took the wheels off for gluing the tires...and i noticed that if u tighten down the front ones too tight, they dont spin...so i just found a ncie place where its tight and spin freely..am i wrong, or is there a certain amount i should be tightening?
Also, when one back tire is spun by hand, should the other one spin too? I noticed on some of my friends nitro cars that the other rear tire will spin in the opposite dirrection...i notice the NR has 2 drive shafts too..i think?
Also, i was looking at those turn buckle and camber rods, and in the front the lower ones seem to be a bit loose..is this right? The top ones are tigher...and do u guys have any good techniques for adjusting the camber and toe? or should i leave it how it is outta the box? The rear tires look like they are slightly bent towards the truck..kinda like the front tire camber...but they dont seem to be parrallel to the truck.?
Anyway..im just a bit first time hazy...some some reassuance would be helpful!
Thanks a bunch!