I need some help? Sevro problem

[mad_mudder]

I was running my nitro pede and it was running great untill i jumped it and it lande hard and fliped. I thought everything was ok untill i gave it some gas and braked. So when i was at a stand still (without me giving it gas) the trottle would open up almost all the way then it would stop then go then stop without me doing anything to it.
So can someone help? It would save me alot of time and money takeing it in to the hobbie shop.
Thanks

[TMAXX MASHER]

you have a glitch, you didn't say if anything got wet and i doubt its the servo itself most likely you damaged a crystal in the reciever, try changing your crystals.

later

[N.stampedeJustin]

i had that problem but it was my controller had something wrong

[RaReKiNd]

I also had the same problem it is your on off switch!!!!!!!i removed mine and soldered in deans plugs to replace the switch!!!It now works great.It could also be your antenna,If it has bare spots from roll over crashes like mine did that could also be your problem but i bet it is on off switch.My N-Pede took off at full throttle for about 100 yards and smashed into a parked car!!!Resulting in only a broken stearing arm!!!GO figure 1 TOUGH TRUCK!!!!

[LifeIsGood]

Im new at this so it may sound stupid to all you "experts" when i first got mine it did something similar which scared the creap outta me because it kept throttling around turns and flipping but your receiver batteries could be weak that was my problem tell me if it works

------------------
...The guy who always has a question...

[mad_mudder]

That was the problem.I'm stupid, I sould of thought of that first.
Thanks