Search:

Well everyone is going to have a different input on this, rpm products are great upgrade from the stock parts.

Congratulations on the pede! IMO I think it the best truck they make :thumbup:

20% is what always ran in mine and good results too.

it is a waste off money for the most part, IMO it will give you a ball park idea is all. if you had all the supply's already laying around that's one thing (or already came equipped on you rc).

Key is to remove all snow after running it dry off well (compressed air works well here). Bearings I would clean well and soak in some motor oil overnight (maybe do this before the snow really hit...

I believe it was the ac680 I sent that back for refund. And then took the hour drive to a not so close LHS and picked up a Hyperion. I thinks it's been over a year now and no problems and charges...

plus one on this best money I spent on a charger ..... After going the cheaper route witch was dead in a weeks time. Just save the money now and headache, with out it your rc is going no where.

They are of great quality and A+ service, you will be happy way on down the road with them.

Sent you a pm

Sounds like you maybe might not be doing proper care of the packs charging/storing? There should be no need for a refrigerator to keep them up and going IMO.

plus one on this one two from experience myself as well, best thing change some rules in the house on the console/computer games it rotting there brain! And get the boy outside to do what kids do...

Back when I had mine I threw this on http://www.integy.com/st_prod.html?p_prodid=3955&p_catid=91#.UCb-6Wt5mSM with stock body I just dremeled a hole. It stuck out just slightly but not to much on a...

Here is a good reading you can look threw since your new to electric scene http://www.rchelicopterfun.com/rc-lipo-batteries.html . As you will read in this going with a higher c-rating is good and...

Just throw in a inline switch.

I think as long as its offroad and a gasser it would take off, they need to jump into this segment with losi HPI ect ect and help get some more support from a well know company (traxxas in this case)...

Well if you do get the jato rpm wide bumper and arms to start, replace as needed since your on a budget IMO. As far as should you get on listen to your brother they do require a lot more and cost...

Clean the shock off well before you take apart, and replace the oil. You should stick with the same oil weight for your pair off shocks.

you have us beat here by a few degrees, I myself I'm going to hate to see my electric bill next month :((

yeah my bad the heat does not have me thinking right! But yes the teslas are cool cars.

No but I think as time goes buy that's going to be the future for sure. I would love to see it happen sooner then later myself. Just have to wait for the technology to play catch up now with the...

I think the best would be your lipo's for the cost and performance compared to LiFe IMO. Just need a charger if you don't already own one and you should be pleased with the outcome in you performance...

If your already running the brushless set up its not going to take long for the others to jump on the brushless wagon. I would just get them from the start if there able to swing the extra cost IMO....

IMO if you get your gearing right you should not need a heat sink, they will not hurt for sure though. I would grab a alloy tranny case if anything they help out a lot for your 3s packs.

I always liked this site and I bought my jato threw them, fast shipping too hope it helps http://www.rcsuperstore.com/SearchResults.asp?Search=Jato&Search.x=11&Search.y=9

If I had to say the one on the right is your over flow line, incase you end up tipping it on its side gas will drain out that instead of in the engine.