Search:

I used the gel version of super glue on my son's rusty (all I had atm) and works like a champ. Once the old tires were off, its was easy, just took my time glued them well and wrapped rubber band...

There's nothing to LiPo's. Proper charger (LiPo capable) , with a balance of some sort and you'll be fine. As long as your rc is equipped with Low Voltage Detect ( Im pretty sure all current Traxxas...

solid info- thanks Max

Explain more about this would ya? Are you using the batt pack to run servo's? Got pics?

ezstart has a glow plug light on it, if it lights when you push the button, its usually good.

Thats just gross....one more reason to be weary of those evil creatures!

Im in central TX- was a beautiful 75 today. Will pre-heat on first start for sure, will monitor temps, probably wont need to wrap. Its a TRX motor, wish it was a Picco! It will be once I get this...

I picked up my new power plant for my Maxx. After the last fiasco with seals on a new 3.3 I decided to pull this one down and check seals. Pulled carb, right out of the box, found this...

...

Perfect, thx Wslash!

So I am going to pick up my new 3.3 tomorrow at my LHS and hope to knock out the break in this weekend. Are there any options for diff carbs for this motor? Just a curiosity really. Would my truck...

Good, glad to see were all pretty much on the same page. I figured with the debris that I found inside, a bearing had to be at fault, and that they would all have to be replaced. NN- tell me, or...

NN, and you other veterans..... where would you go from here? Piston/Sleeve kit? I would think all new seals too, just for kicks....or just do the Traxxas replacement prog @ my LHS?

well...I decided to go ahead an pull this lil engine down, and toss all new seals at it, just in case they were the source of my problems. upon tear down, I think I might have found a leak at the...

tell me more about the leak you had w your 3.3...mine is new as well, and leaking. might run down to LHS today and pick up a bearing/seals for mine.

Double please! Or atleast a parts list? I can figure out the rest on my own. Question tho, do those sway mounts interfere with the shocks at all? From the angle of the pic its looks wicked close!
...

I didnt think fuel in pressure line was right. It seemed to range from just small amounts, to alot at times.

As for exhaust... Checked both the coupler and the pipe this morning. Found a small...

I have checked fuel lines (new w motor) header o ring, and tank seal...I only get the occasional air bubble in the tank to carb line. I have noticed there is usually some fuel in the exhaust line....

TRX- yes, its seems to need tuning every single time I fire it up. Its getting to the point I usually just pick up the VXL Rusty, because its all thrill, no fill.... It erk's me to no end, because im...

Hey guys, have had a T-maxx for a couple months now, that I bought on the cheap with a worn out 2.5. After lots of searching and digging around this site I determined it needed to be replaced. I...