Search:

Makes a good drifter. And nah same as when I started with the power it producers at the wheels it was pretty much just floating on the surface.

Got the stampede out at work the other day nice new concrete slab so slippery so mush fun hope you like. sorry about noise it was very windy. and it was only i phone in hand while driving dont be...

just looked on stampede page on traxxas part number #6869 and cant wait to get them in 3 years when they become available in australia hahhaah

rpm slash 4x4 raer bumper with wheellie bar option works good

Go the mega heat sink fan just search this forum it's about3 pages back now

slipper pads look good just while i was thinking and going over car missed some thing out. It was shuttering very bad after it cane to a stop and i was about to take of again never happened with 11...

hi i just installed the 17 tooth pinion for a bit of fun out the front on the road. now i got mega fan installed and esc fan but after about 15 mins of straight hi speed runs with trenchers balloning...

check to see if antenna in the car is all the way to the end of the tube. And as far as i know the cars receiver can only store one transmitter at a time un like transmitter witch can store 20 cars...

Check private message sent or search mega heat sink/fan

The Phillip head screws are for the part where you get the small hex screw up the top of the carrier camber link I think I just used all the original hardware mine is going good and strong with it
...

Get fans for both esc and motor

It just pushes through the pin is a lil smaller then original screw I didn't think the e clip would hold up or if I hit it on a weird angle it would pop of so I used the original screw. My question...

The lipo version and nimh version are the exact same car only diferance are battery's man. No matter what one you buy you can run either battery just have to make sure when you run lipo that the LVD...

Thanks people just brought the slash 4x4 rear bumper and wheels just because it takes around 4 weeks for tbone stuff to arrive once I am ready I will get both front and rear tbone bumpers thanks a...

Hi I was just wondering any good wheliebar options mine snapped in half yesterday and the mounting screw popped out of its hole. So just chasing a good upgrade options thanks

Clean bearings well, coz if you don't they'll seize on you.


What are the main berrings to clean. And what is the best way to clean please

Yeah I will be carefull heard some stuff about them. And in Australia they are around $90 so yes winning like I said I had to share it news

Hi just thought i should share this deal. went to LHS to grab last 6852x in stock. the bloke behind the counter told me it got sold about 2 hrs before. me a lil angry asked when the where coming in...

Nah man thanks for the warning now I will know what to look for

Do you know of a way to fix the issue I have the aluminum carriers. And just ordered the rear mip x dutys

Man looks good for first body. Don't take the wrong way but why did you cut so much out of the wheel wells and by the looks front bumper

It goes hard after a few years but it is easy to remove you just have to clean it with acetone or rubbing alcohol won't epoxy it together

The way that looks I don't think anything would of saved it

so two days ago i broke top part of rear half shaft

http://i1301.photobucket.com/albums/ag104/Jeff_Reylane/IMG_0915_zps82e4c1f6.jpg

installed new ones same day
...

what did you think of the Traxxas steel constant velocity shafts in australia the mips cost with shipping dont seam worth it for me