Search:

If you had actually read my other posts, I do have previous experience with nitro cars and have engine break in experience. And no, it's not supposed to spit raw fuel out of the exhaust. Anyone with...

Thanks for the information.

Peter

I am thinking about buying a Integy Steel Rollcage for my Maxx 3.3. I was wondering if anyone who has one could tell me if the stock body will fit over it?

Peter

I had said Mid Speed Needle but on the 3.3 it's actually the Low Speed Needle. Its just in the place that some carbs have the MSN located. Sorry for the confusion there.

Peter

Thanks to everyone for the input. I fully understand how nitro engines work as I have had past experience with nitro cars. My question at this point then would be, is it normal for an engine at...

Thank's guys for the info and advice. I took a deep breath, went back outside, put my tuning cap on straight and thought the whole process through step by step. I finally got the motor to where it...

I tried starting my T-MAXX 3.3 for the first time today and it just would not start. It kept flooding out. I would follow the clearing instructions and it would just flood all over again. I finally...

When you change anything like that, you will have to re-tune. The new pressures and feed of fuel is what requires the re-tune. From what you mentioned in your post sounds like you may have had air...

RCScrewz

I have bought a bunch of stuff from them.

Peter

What is the difference between PM, PL, and PKS?

Peter

Has anyone added the Telemetry stuff to their T-Maxx? Thoughts, impressions, is it worth the extra money?

Peter

My order is being delayed 4 days due to lack of availability of the Heavy Duty Clutch Rebuild Kit. I found that out after calling them and the guy I spoke to was really helpful. I will definitely do...

I ordered my Truck today from Tower Hobbies and some upgrade stuff from RC Planet. Anyone have any experience good or bad with RC Planet? How quickly do they ship stuff? Is their customer service any...

Also check the connections at your reciver and make sure nothing has worked itself loose.

Peter

Thanks for the info.

Peter

I'm not able to watch the video right now because I'm at work but I assume you are talking about doing a wheelie from a standing start? Could be something in your radio that is limiting the throttle...

In years past I had seen it done with the engine bolted to a bench and a airplane prop on the output shaft for the load. But as Snook Man mentioned, if you don't have the experience, I wouldn't...

If a engine gets too much fuel in it, it will lock up like that. Its called fuel locking. Take the glow plug out, turn the truck upside down with the glow plug hole pointing down and try pull...

By Upgraded Slipper Clutch, what am I looking for? I am buying my stuff from Tower Hobbies and they have a Robinson Racing Slipper Clutch - Here. Is that what I should get or am I totally off on what...

If only I had that kind of money.

A T-Maxx 3.3 it is. I'm placing the order at Tower Hobbies tomorrow morning. I'm super excited as I have a HPI RS4 Type 3 from some years ago but this will be my first Nitro Truck.

Peter

I'm still new to nitro but have some limited experience with a nitro street car. If you think about what you said about having to stick your finger down the carb, that tells me the carb is set too...

I was able to find what I was looking for at RCGroups. I forgot I was registered there from my helicopter days. Thanks for the reply though.

Peter

I'm putting together a list of things to get with the Slayer I plan on buying for my birthday. So are I have the truck itself, upgraded bearings all the way around, and a rechargeable receiver...

I am looking to buy my T-Maxx 3.3 this week for my birthday and was wondering if anyone had a $50 Off or more coupon code they wouldn't mind sharing. I just joined the Super Saver Club last night but...