Search:

Type: Posts; User: dodgeguy72

Search: Search took 0.22 seconds.

  1. Things I would try, Setting the carb leaner,...

    Things I would try,

    Setting the carb leaner, due to your higher ambient temp, factory is 4 turns out, I would try 3.5 on the HSN and check that the LSN is flush with the inside grey ring.
    ...
  2. Replies
    19
    Views
    788

    I too run Sidewinder, being the only fuel my LHS...

    I too run Sidewinder, being the only fuel my LHS sells. My Revo runs great around 250 deg.
  3. Replies
    6
    Views
    525

    Sounds like you may have an air leak somewhere,...

    Sounds like you may have an air leak somewhere, I'd start with the O ring on the tank cap, if not that check the fuel lines for pin holes ( bubbles in fuel line when running ) if not any of those...
  4. Replies
    71
    Views
    1,337

    I've got a lime green 1972 Dodge Demon 340,...

    I've got a lime green 1972 Dodge Demon 340, pretty rare and fun to drive. I'll try and post some pics.
  5. Replies
    11
    Views
    1,008

    Thanks OvalQueen, I did what you said and...

    Thanks OvalQueen, I did what you said and everything feels tight :D
  6. Replies
    11
    Views
    1,008

    How to tell if a diff is bad

    Can someone tell me how to properly check the diffs? How it should feel ect..
  7. Replies
    17
    Views
    375

    Try richening it a little and lower the shift...

    Try richening it a little and lower the shift point.
  8. Replies
    3
    Views
    198

    Do you have access to a temp gauge? If not you...

    Do you have access to a temp gauge? If not you can do the spit test, if it evaporates quikly, you will know it will jump around, then I would recommend richening the HSN a 1/4 turn counter...
  9. Replies
    18
    Views
    700

    I thought from pictures that the A arms looked...

    I thought from pictures that the A arms looked thin, they are actually pretty solid.
  10. Replies
    6
    Views
    220

    I'm using Morgan Fuel Sidewinder 20% nitro 12%...

    I'm using Morgan Fuel Sidewinder 20% nitro 12% oil, this stuff says not to use after run oils because it has a rust inhibitor and anti oxidents. I still do the after run maintenance anyway because I...
  11. I'm using the O.S. LC3 and it works great, I...

    I'm using the O.S. LC3 and it works great, I would have at least 2 on hand. Or use the traxxas 3231 or 3232.
  12. Replies
    3
    Views
    278

    I too am running the O.S. A3 and it runs good...

    I too am running the O.S. A3 and it runs good same temps as Staats. I'm going to pick up some O.S. LC3 when I get a chance, they're longer like the Traxxas plug.
  13. Replies
    1,529
    Views
    919,741

    Sticky: Here is a link to a couple of pics. ...

    Here is a link to a couple of pics.

    home.cogeco.ca/~abland/mypage.html
  14. Replies
    0
    Views
    909

    Another glow plug question

    My original plug in my Revo 2.5R was not any good. I installed an O.S. A3 for the break in,

    What effect would a shorter plug have on the engine? I only had the A3's and A5 on hand and my LHS was...
  15. Replies
    66
    Views
    1,115

    I would seriously look at the Acura TL 2004, very...

    I would seriously look at the Acura TL 2004, very nice driving car, yes it's fwd, nice styling and comfortable.
  16. Replies
    4
    Views
    243

    The manual says like 15, I read on here that...

    The manual says like 15, I read on here that someone thought it was excessive, I put around 10 and it was well covered.
  17. Replies
    3
    Views
    256

    I noticed when I removed the traxxas plug that it...

    I noticed when I removed the traxxas plug that it was longer, I had a couple spare A3's for my rc10 gt which runs at 220 - 230 consistantly.

    Anybody else know if the shorter plug would cause it...
  18. Replies
    3
    Views
    256

    Did break in today

    I just broke my Revo in today, the original plug turned out to be no good, so I replaced it with an O.S. A3 for the breakin, first tank 1/4 throttle I had temps of 194 to 220, 1/2 throttle I was...
  19. Replies
    90
    Views
    2,823

    Hey there, I just got my Revo yesterday, haven't...

    Hey there, I just got my Revo yesterday, haven't had a chance to break it in yet.
    Anyway I see what people are talking about with suspension travel.
    Just by picking up the truck it puts stress on...
  20. Replies
    19
    Views
    603

    4G63Turbo Thanks for the information, I went...

    4G63Turbo

    Thanks for the information, I went today and picked one up. Probably brake it in tomorrow after I read the manual. :D

    Thanks everyone
  21. Replies
    19
    Views
    603

    Canadian Revo's

    I did a search trying to find out the duty cost for importing a Revo
    and found nothing that helped.

    So my question is how much did it cost you to import, taxes, duty and shipping cost?

    Thanks
Results 1 to 21 of 23