Search:

Type: Posts; User: Stampeedee

Page 1 of 20 1 2 3 4

Search: Search took 0.32 seconds.

  1. Replies
    5
    Views
    585

    I suspect I have a faulty controller. Throttling...

    I suspect I have a faulty controller. Throttling up lightly where it will not lift off while manipulating the right stick results in very obvious changes in motor RMPs, EXCEPT for when I go right. I...
  2. Replies
    5
    Views
    585

    Would it even fly like that? There are two sets...

    Would it even fly like that? There are two sets of props, one for CW rotation and another for CCW rotation. Are you suggesting maybe you have three of one and one of the other somehow? :O.o:
  3. Replies
    5
    Views
    585

    Ok, it's not just hard right. If I'm drifting...

    Ok, it's not just hard right. If I'm drifting left (from momentum) and try to bank right any, it won't go right for a second or two. If I am hovering, it will go slight right, then pause, then it...
  4. Replies
    33
    Views
    2,080

    That's a great idea with the foam plugs. I have a...

    That's a great idea with the foam plugs. I have a bunch of fluorescent yellow ones. I think I would like to try something less permanent than gorilla glue to make sure I like it though. I assume you...
  5. Replies
    5
    Views
    585

    Hesitation banking right (QR1)

    My QR1 has this weird hesitation when I command it to bank right hard, it immediately goes in to a slight bank, hesitates noticeably, then snaps to a hard bank right. This doesn't happen in any other...
  6. Replies
    52
    Views
    3,451

    And now... The following were shipped from our...

    And now...

    The following were shipped from our Champaign, Illinois distribution center on 30-Nov-2012

    TRAE62RL Traxxas QR-1 Quad-Rotor Helicopter RTF Red/Black

    So it is a waiting game...
  7. Replies
    52
    Views
    3,451

    Yep! Checked my account and: "Order Now Being...

    Yep! Checked my account and: "Order Now Being Picked and Packed in Warehouse" :)
  8. Replies
    52
    Views
    3,451

    Tower Hobbies switched their status from "Order...

    Tower Hobbies switched their status from "Order Pending" to "Late November". It can't get much later in November... heh heh.
  9. Replies
    2
    Views
    520

    Nice. The parts list for the QR-1 is at the end...

    Nice. The parts list for the QR-1 is at the end of it's manual BTW. Not that there are many parts that can be purchased: motors, blades, body, battery, and transmitter.
  10. Replies
    2
    Views
    435

    They only thing I can remember Traxxas NOT...

    They only thing I can remember Traxxas NOT selling separately that came in the box is... the box. ;)
  11. Replies
    10
    Views
    1,479

    I went ahead and bought one. I don't have a quad...

    I went ahead and bought one. I don't have a quad yet. I'll be using it when it is too scorching hot outside to mess with my trucks or planes.
  12. Replies
    28
    Views
    21,428

    I'm guessing this is the motor: mabuchi motor...

    I'm guessing this is the motor:

    mabuchi motor
  13. I am familiar with that operation from my...

    I am familiar with that operation from my electric planes. Sometimes I have to adjust the endpoint so the ESC will arm.

    In this case, it doesn't work though. :(
  14. Yes, I discovered that it needs to be reversed....

    Yes, I discovered that it needs to be reversed. Even so, it still won't set up properly. I can drive forward, and reverse, but no brakes. The only thing I can figure out that causes this behavior is...
  15. EVX-2 setup + Futaba 3PJ Super = frustration. Help please!

    I transplanted my Futaba FM receiver that was in my E-Maxx to my E-Revo, replacing the AM system. Everything worked fine with the AM.

    The problem is (I think) I can never complete the EVX-2 setup....
  16. I've been away from the hobby for a while (R/C...

    I've been away from the hobby for a while (R/C airplanes instead), but had to buy an E-Revo when it came out!

    Anyway, I think these would be useful. They sure help a lot with CA application during...
  17. Replies
    3
    Views
    266

    The big boss at CC has stated the failure rate is...

    The big boss at CC has stated the failure rate is about 15% within the first few hours. It's been traced to a single component. They're reworking it to use a different part. Bad luck!

    I've been in...
  18. Replies
    0
    Views
    259

    Stock E-Revo: first impressions

    Yeah, I wanted to get my 2 cents in too...

    This is the first Traxxas product I've purchased in a while. The last being the E-Maxx (not the current one, the one before).

    I've stated on this...
  19. Thread: Manuals?

    by Stampeedee
    Replies
    13
    Views
    662

    Someone forgot to turn on the switch....

    Someone forgot to turn on the switch....
  20. Replies
    13
    Views
    415

    I didn't see the number of amps it is capable at...

    I didn't see the number of amps it is capable at the radio shack website, but it is 3.0A. Not GREAT, but I guess it depends on how fast you want to charge your batts...

    What dude, what...
  21. I asked Traxxas about the grey vs. black plastic...

    And the response was:

    "The grey parts are grey and that is the only difference as far as I have been made aware."

    I imagine the less flexing and extra weight might be due to the extra material.
  22. Replies
    25
    Views
    774

    RPM box dimensions...

    I don't have it with me right now, but this should give you an idea of the size:

    RPM box on my Rustler
  23. Replies
    7
    Views
    348

    Naw... they've been marketing it forever! More...

    Naw... they've been marketing it forever! More like Many Months from Manufacturing...
  24. Replies
    31
    Views
    943

    So I got some at my LHS...

    The instructions say to remove 1mm of material from the chassis or the boot may rub. Has anyone done this? How'd you do it without going through the chassis, i.e. too far? I'm a little concerned...
  25. Replies
    32
    Views
    1,367

    Interesting to compare your results to mine

    Check out these old threads:

    My heat sink/themal paste effectiveness tests

    and...

    My motor spaceer vs. heatsink tests

    Note that in the last one, I had the old style titans that didn't...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4