Search:

Type: Posts; User: BR photo

Page 1 of 2 1 2

Search: Search took 0.10 seconds.

  1. Replies
    6
    Views
    438

    Ok so the servo has quiet working and I switched...

    Ok so the servo has quiet working and I switched it manually a few times and today the truck will not move, when I hit the gas the motor just spins. I think I stripped something in the transmission....
  2. Replies
    6
    Views
    438

    Low gear high gear

    Hey I have a new summit, all stock and running 2s 50c 8200mah battieres. I have ran about 10 packs through and it has started not wanting to go in low gear. The crazy thing is I can go in low gear...
  3. Replies
    7
    Views
    211

    Can you turn the pinion gear by hand it should...

    Can you turn the pinion gear by hand it should turn very easy when the motor is off, if so i would have to send it back to Traxxas to let them look at it, they will will probably want you to send the...
  4. Replies
    7
    Views
    211

    Does it roll fine when you just push it, it...

    Does it roll fine when you just push it, it should roll smooth. You may want to get a vxl motor rebuild kit the bearings in the motor do go bad. I have done this to mine twice and it runs like new...
  5. If the temp on the motor stays below 160 is it ok...

    If the temp on the motor stays below 160 is it ok to run it 45 min with out stoping?
  6. Is the 50c ok it seems to take off a faster or is...

    Is the 50c ok it seems to take off a faster or is that just because it is a 2s Li-Po?
  7. Is this battery to much on the stock motor?

    I bought the (SPC Li-Po Power,Lithium Polymer (LiPo) Battery Pack; 8200mAh, 50C, 2S2P, 7.4V) for my stock 4x4 is this too much for that motor, i have only ran the pack twice and i have a crunchy...
  8. Replies
    9
    Views
    255

    The range is very good i have had mine over 400...

    The range is very good i have had mine over 400 feet away and maybe more because i could not tell which direction it was
    going because it was so far away.
  9. Replies
    9
    Views
    255

    you can get all the telemetry stuff the chop shop...

    you can get all the telemetry stuff the chop shop as well i think i paid $20 for all the sensors.
  10. Replies
    15
    Views
    368

    Where can you get a better bearing than the...

    Where can you get a better bearing than the traxxas ones?
  11. Thread: Spy camera?

    by BR photo
    Replies
    20
    Views
    538

    New the drone is $300, and you do not need...

    New the drone is $300, and you do not need internet you just need a smart phone or tablet.
  12. Thread: Spy camera?

    by BR photo
    Replies
    20
    Views
    538

    i have the AR drone 2.0 and you can see live...

    i have the AR drone 2.0 and you can see live video on you ipad or iphone as you fly it. You can take still pics or video also.
    So if you do not want to buy a new toy then i would look for one that...
  13. Replies
    17
    Views
    695

    i have a slash 4x4 stock motor and stock gears i...

    i have a slash 4x4 stock motor and stock gears i also have the telemetry to show my speed and i get 35mph with the stock
    battery and with the 3s i got 53mph and that was on a grave/grass area.
  14. Replies
    1
    Views
    109

    No brakes and half speed

    Ok I posted this before but I have figured out the problem but need help fixing it.
    It is not the motor or the esc it is the receiver or transmitter.
    I can switch the steering and throttle channels...
  15. I miss spell my name some days, but i can run...

    I miss spell my name some days, but i can run numbers around most people just one of those things, but thanks for grammar
    lesson :thumbup:
  16. I miss spell my name some days, but i can run...

    I miss spell my name some days, but i can run numbers around most people just one of those things, but thanks for grammar
    lesson :thumbup:
  17. ok well just test my motor on a friends slash and...

    ok well just test my motor on a friends slash and it worked just fine, so i test his motor on my slash and same problem so it must be the esc.

    If i just want a good all around bashing motor combo...
  18. Replies
    5
    Views
    259

    sounds like a good deal.

    sounds like a good deal.
  19. I did I did not want to spend $200 for new motor...

    I did I did not want to spend $200 for new motor and esc got it it for $52, what should I look at when this one goes out and not spending $200.
  20. Ok I tried the slipper clutch and still no luck....

    Ok I tried the slipper clutch and still no luck. So I ran the motor with no clutch in and when I put on the breaks the motor just gradually slowed down so I ordered a new motor we will see if that is...
  21. Replies
    6
    Views
    234

    the docking station should not make any...

    the docking station should not make any difference on that, i have never maxed mine out i have had it so far away i could not see it good enough to tell what direction it was going. It was at least...
  22. i do have a fan on the esc and i put a brand new...

    i do have a fan on the esc and i put a brand new slipper clutch in it the week before so i will ck that. thanks for all the ideas.
  23. i did do that i tried two nimh and my 3s lipo and...

    i did do that i tried two nimh and my 3s lipo and still same thing, it does go faster with the lipo but not full speed and still
    no breaks.
  24. Ok tried that and still no luck, I think it is...

    Ok tried that and still no luck, I think it is esc or motor.
  25. No breaks and half speed on stock 4x4 slash

    Ok I have a stock slash 4x4 took it out yesterday ran it for 20 min no problems.

    Took it out today and it runs at half speed or less and I have no breaks.

    I know it is not on training mode...
Results 1 to 25 of 32
Page 1 of 2 1 2