Search:

Shot some video over the weekend. Check it out. :cool:


http://www.youtube.com/watch?v=tIr3G3EIuOc

The engine might be flooding. Make sure you a have fresh glow plug and try using a glow igniter to start it. Got some video?

Thanks

Update:
So this system was working fine until it started blowing glow plugs non stop :mad:. Turns out the voltage regulator in the ROSS unit must have went bad and was sending the entire...

maybe the antenna wire in your TX is unplugged form the board.

In order to control the lights with your remote you would need something called a "receiver controlled switch", just google it. This is one way I know, I'm sure there are other ways as well.

Looks clean for sure. Did you use WD40?

That lipo should work fine. Don't know about the connector though. I cut the connectors off and put on Traxxas ones.

Maybe your steering Servo stripped a gear?

^^ I've done this on my Nitro Revo and has worked great. Easy and cheap...

Yes if you took reverse out you could use the 3rd channel to operate the remote start. I've been using it for a few months now with no problems. Works every time!

Mine did the same thing, it was unresponsive with the USB too. Turned out to be a defective one, I called castle and they mailed me a new one.

+1 on the cap pack. They're cheap and you can even make your own for a few dollars.

Same here I run 20% VP powermaster and noticed more power, its cheaper than the others at my LHS too.

Palisades area sounds good, even around Nanuet or Nyack area. Traxstar whereabouts are you located?

They are great, any reasonably priced. They ship quick too.

I like it, i'm in too! Sometime in March sounds good, lets get some tentative dates set!

Like the other posts said, it appears your High Speed needle is too lean and the Low Speed needle is too rich. Go back to factory carb settings, tune with tank half full and start with the High Speed...

Make sure you have a fresh glow plug, fresh nitro and it would't hurt to start at factory carb settings. Be patient, you will need to make tune adjustments regularly as the weather changes but that...

I have 2 X 35v 1000uf ZLH Rubycon caps. They work great.

Same thing happened on my Summit VXL transmitter, quick easy fix. I get well over 150ft range now.

OS 21TM for Revo

Same here, after my 3.3 is toast im getting the OS 21.

I also use powermaster 20% nitro, very pleased with it.

looks good, I like it!

Maybe one of the screw pins from the rear came out. This happened to my Revo 2 days after I got it, it was only running on Front wheel drive. Cheap fix...