Search:

Type: Posts; User: Josh4908

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    502

    Works fine with a receiver pack. I'm using it on...

    Works fine with a receiver pack. I'm using it on the throttle. I have a hitec hs5645mg on the stearing. I only said something about that Futaba because most hobby shops keep them in stock.Just...
  2. Thread: bearings

    by Josh4908
    Replies
    10
    Views
    307

    What kind of lube do u use?

    What kind of lube do u use?
  3. Replies
    13
    Views
    502

    Futaba s3305. 35 plus tax the hobby shop. All...

    Futaba s3305. 35 plus tax the hobby shop. All metal gears and if I'm not mistaken about the same amount of torque as the savox servo
  4. Thread: bearings

    by Josh4908
    Replies
    10
    Views
    307

    Acer racing has a complete set. Check there site...

    Acer racing has a complete set. Check there site or give them a call. But I like avid bearings top quilty and super cheep.
  5. Thread: oh my luck...

    by Josh4908
    Replies
    14
    Views
    552

    its not a little its a lot. i only run a rrp...

    its not a little its a lot. i only run a rrp steal top shaft and first gear. an it works out great. less rotational mass in the tranny means more power to the ground and its not as hard on the engine...
  6. Thread: Toe links

    by Josh4908
    Replies
    6
    Views
    269

    YUP YUP! good lookin on the links wildman. i was...

    YUP YUP! good lookin on the links wildman. i was to tired to look all that up last night.
  7. Thread: Toe links

    by Josh4908
    Replies
    6
    Views
    269

    those are for maxxs with the revo spec axel...

    those are for maxxs with the revo spec axel carriers. the 2.5 uses shorter toe links.
    4910 2.5 uses 106mm in the front and 116mm in the rear. non revo spec
    4908/07 3.3 uses 112mm in the front and...
  8. Thread: talon tires

    by Josh4908
    Replies
    8
    Views
    323

    i cut the splines out of the wheel so i didnt...

    i cut the splines out of the wheel so i didnt have to use the traxxas hexes. i use the 17mm hexes and nylock nut from the savage X 5.9
  9. Thread: Is it time

    by Josh4908
    Replies
    12
    Views
    361

    word!!!!!!!!!

    word!!!!!!!!!
  10. Replies
    53
    Views
    727

    its a pain with the stock tank.thats y i did the...

    its a pain with the stock tank.thats y i did the vialator tank and direct pull servo mods
  11. Replies
    53
    Views
    727

    set that idle screw to 1mm gap also.a paper clip...

    set that idle screw to 1mm gap also.a paper clip works well for doing this or a 1mm allen key
  12. Replies
    53
    Views
    727

    yeah i read his other post. u never know that...

    yeah i read his other post. u never know that looked like it took a pretty hard hit. maybe a craked carb body if nothing else its worth a shot to lookyeah i turned the first one i ever had in to far...
  13. Replies
    53
    Views
    727

    1.75 turns out or flush with the inside of the...

    1.75 turns out or flush with the inside of the housing.i like the 1.75 turns from closed as a starting point because not all of them are in the same place
  14. Replies
    53
    Views
    727

    not always the case if the lsn is a little bit on...

    not always the case if the lsn is a little bit on the lean side to small of a gape can make it idle high. i only know this from experience. if that doesnt work try to richen the lsn 1/16 turns and...
  15. Replies
    53
    Views
    727

    that noise when you roll it should not be there....

    that noise when you roll it should not be there. should roll nice and smooth and just spin the gear when pulled backwards. as far as the high idle. it looks like your carb gap my be a little tight...
  16. Replies
    53
    Views
    727

    check your throttle trim. make sure its set in...

    check your throttle trim. make sure its set in the middle or at
    zero.
  17. Replies
    1,142
    Views
    616,673

    Sticky: MY BEAST!!! Not so stock anymore! ...

    MY BEAST!!! Not so stock anymore!
    ...
  18. Replies
    10
    Views
    963

    My picco maxx .26 chews up and spitts out...

    My picco maxx .26 chews up and spitts out trx3.3's. lol. but on a side note u better beef up that driveline or it will just toast the diffs. i was litterly grinding plastic diff cups into pieces even...
  19. Replies
    29
    Views
    1,628

    On tower hobbies picco 26 maxx is 199.99 and the...

    On tower hobbies picco 26 maxx is 199.99 and the mount is 19.69 and u would get free shipping too. I did forget to mention I sealed the whole engine with sensor safe orange rtv.
  20. Replies
    29
    Views
    1,628

    My picco chews up and spits out driveline Co...

    My picco chews up and spits out driveline Co
    mponets. Plan on upgrading all diff. Parts to handle the power. I have a steal top shaft gear and first gear is steal also. Aluminum diff cups in the...
  21. Thread: tire question

    by Josh4908
    Replies
    20
    Views
    2,351

    I had trouble with the rear no matter what...

    I had trouble with the rear no matter what truthfully. It didn't matter what tire/wheel combo i ran. The rear end would always be outta wack half way through the first tank of the day. That's why I...
  22. Thread: tire question

    by Josh4908
    Replies
    20
    Views
    2,351

    http://i1133.photobucket.com/albums/m588/Josh4908/...

    http://i1133.photobucket.com/albums/m588/Josh4908/image-5.jpg http://i1133.photobucket.com/albums/m588/Josh4908/image-4.jpg http://i1133.photobucket.com/albums/m588/Josh4908/image-3.jpg
    Theres...
  23. Thread: tire question

    by Josh4908
    Replies
    20
    Views
    2,351

    My geodes were chrome but when they got beat up...

    My geodes were chrome but when they got beat up and it started chipping so I painted them red. I'll post some pics from the front and back shortly. I might even have a pic of the geodes chrome still...
  24. Thread: tire question

    by Josh4908
    Replies
    20
    Views
    2,351

    Badlands on traxxas...

    Badlands on traxxas geodeshttp://i1133.photobucket.com/albums/m588/Josh4908/image-2.jpg
    http://i1133.photobucket.com/albums/m588/Josh4908/image-1.jpg
Results 1 to 24 of 24