Search:

How much run time should I get from spc 2500 2s & spc 1500 3s.
The reason I ask is that for both batteries I am getting less than 5 mins of run time.
I have stock motor with ezrun 60a esc.
I...

Hey MTV,
Which ones are for the rockers and the steering servo saver.
Thanks

I am so glad that I went with 50's recommendations....
Get hr shock bodies, summit red seal, gpm springs (you can buy three spring sets for around $10), use a blue- black- blue o ring combo to seal...

Walmart sells chains in small boxes and the one that I was looking into for some snow chains was for $5-6 for a box of 20 foot chain. Its in their electrical/ hardward isle. you cant miss it or just...

Is there an option of punching a hole in the motor mount plate....
The size of the hole can be slightly bigger than the pinion gear so that some part of the pinion sits inside/through the hole.
I...

Hi ...
I dont run the merv everyday but keep the lipos fully charged so that I dont need to charge them when I need them.
Questions:
1. how long can I keep a fully charged lipo (2s & 3s) before...

50 is absolutely correct ... I followed his recommendations and am happy with the results.
Hr shock bodies, rpm springs (1. They are taller than stock springs therefore you don't need to add much...

50 is absolutely correct ... I followed his recommendations and am happy with the results.
Hr shock bodies, rpm springs (1. They are taller than stock springs therefore you don't need to add much...

I needed the water resistant properties so I short listed Hpi vapor pro and ezrun 60a waterproof esc. Finally bought the ezrun with the programming card.
Definitely better than the stock

How much run time can I get from the spc 3s battery.
Mostly speed runs on the road
Thanks

I am using 100wt shock oil with hr bodies and gpm black ( front) and silver (rear) ... With red seals
But I have a heavier car about 2.75 to 3 lbs ....
Ther is no pre load in the front... And very...

I am not a pro like some of the members here
but did my share of research.
I went with ezrun 60A waterproof esc (about $45) with the programming card ... its been a very good experience.
Easy...

Which spacer did you run .... stock or HR?

Why did you replace the middle spacer with the HR o ring?
Is it better to have a spacer or an o ring in the middle ...

Are there any spec difference between the stock o rings and the HR o rings...

Hey 50 ....
I am going to buy the hr bodies and use GPM springs on them.
Where can I find GPM springs only ...
You also mentioned to buy red seals ... where can I get those
Thanks

What is the spring rating for GPM springs (Black, Silver & Gold)
What does the number represent? Is it ... the amount of weight required to compress the spring by 1 inch or something else.
...

On the ez60 with 2s the motor and esc hardly get warm (no where near HOT) ... So even if I take the fan off with 2s I should be fine.
It only with the 3s that I am concerned about.

BTW the fan...

Thanks 50,
In case it fries up.
What are my options ... the current one is 25mm x 25mm x 10mm and this would fit on the ESC fins. Anything bigger might not fit.
That is why I look up the one in...

So I guess I will plug in the 3s and will find out if it survives or not

Jimmie ...
The wire on the fan is very small ... the fan sits on top of the ESC and can only connect to the ESC
Here is what I have ... its the waterproof version...

I have a ezrun 60a esc which comes with a 7v fan.
The instructions say not to use it with 3s Lipo (for obvious reasons).
I really dont need a fan for 2s but was looking into a 12v fan which would...

Ok Great.

If I go with hr bodies, pls. let me know the parts I need to order.
1. red summit pistons (part number). How is this better than the stock piston?
2. tin shafts (part number). How is...

Thanks 50
I read an earlier post, I think it was from you where you had talked about boiling the wings to make them more flexible. Did you boil the ofna?

I was looking at ofna 1/12 scale wing.
Has anyone tried it? Is it a good fit?
Any other options I might have?
I have replaced two stock ones and want to try something different
thanks

Hey Cipher ... why the different combo ... gpm shocks and springs in front and stock shocks and silver gpm springs in the back.

I know that gpm shocks come with 3 sets of spring. Which one is...