pm sent your way
Type: Posts; User: integyjato3.3
pm sent your way
your in box is full. I still want the trans. Send me your payment info please.
Still For sale $400 plus shipping is as low as I will go. If it doesn't sell today then I am going to part it out on Ebay.
No trades looking for cash. thanks $400 plus shipping
$425 plus shipping, make offer
Need to sell, $450 plus shipping of $35 to lower 48 states only.
to the top
bump it up
This is my tmaxx I built. The only thing that is used on the truck is the RPM arms. It will come with a new body as well. I will post a pic of that tomorrow. I have never run the truck so you will...
If your using the FLM ult hybrid rear with their diff and a stock front diff then you are going to have a problem with gear ratio. The rear is an 1/8th scale diff. Not sure what the ratio's are but...
Your ez start charger is 7.2v(if it's the stock wall charger) your hump pack is 6v. Not sure how thats going to work out. That plug looks right, only it's in china. Take weeks to get here.
Nope, sorry I have all the hump packs I need. Look on ebay for an HPI pack and charger. Thats What I use. You can get them for like $20. Works fine and everything just plugs in. will work with the...
Thanks, the tires were alittle off. I hadn't adjusted the radio yet so my servo's and tie rods wern't adjusted. All better now. Heading to Fl Friday so I'm going to take this and my buggy and have...
sell the hump pack you have and buy the right one. 6 volt 5 cell.
What battery box do you have? The newer one's have a spot for the charge plug right on top, under the rubber flap. Unscrew your switch, screw in the new one, install battery and plug it in
Finished it up today. Lost interest for awhile. Moving on to Heli's. But here it is.
Picco .26 JL red dot
Motor saver air filter
RR full steel tranny gears
RR Gen 3 slipper w seel spur
Don't waste your money on telemetry for a nitro. Just buy a temp gun. MPH is worthless on a nitro. Keep you hump pack charged. You don't need tel. IMHO
Hump pack 6V, 4 AA 6V So where do you get more volts? Just wondering
You can see on the rx box where the opti-drive module was and look at the bottom pic and you can see where the reverse servo was. Not 4908 or 07.
Nope I have FLM and had to shave my linkage also
Emaxx is totally dif then a Tmaxx
The hpi 77mm shaft will work. I got the one I ordered for the rear today and tried in the front, Had to play with a couple different cups but it will work :thumbup:
Now I got to wait for another one...
Well I got the FLM front drive shaft kit. I guess I should have looked into it more. The ebay listing stated it was for the tmaxx 3.3. Well it's not.:thumbdown: It's for the FLM chassis when you use...
Get what the slipper?
fuel filter goes between tank and carb