Search:

Type: Posts; User: ksb51rl

Page 1 of 20 1 2 3 4

Search: Search took 0.63 seconds.

  1. That is such a nice job that I would not be...

    That is such a nice job that I would not be surprised to see a company mass-produce them. Of course, it's possible that they were already on somebody's drawing board when the inspiration came to you,...
  2. I suppose we are assuming a Traxxas EPP+ charger....

    I suppose we are assuming a Traxxas EPP+ charger. It has an 80W limit, which you are ignoring. The peak amps will be 80W/16.8V, or 4.76A. Now the answer is about an hour if fully discharged.
    ...
  3. Replies
    1
    Views
    47

    If you'd like to compare Traxxas vehicles, the...

    If you'd like to compare Traxxas vehicles, the correct place to ask the question is the Traxxas Alley. Other manufacturers' vehicles do not belong anywhere on the Traxxas forum.
  4. Replies
    36
    Views
    462

    No, it is not optimal for LiPos (many of us found...

    No, it is not optimal for LiPos (many of us found out the hard way) although it is correct for NiMH packs.
    Although your packs may still be "kicking" they'd be kick harder if treated as recommended...
  5. Replies
    1
    Views
    33

    Although some chargers lower the rate for...

    Although some chargers lower the rate for storage, possible for the sake accuracy, so long as the pack(s) are stored at 3.8 to 3.9 volts per cell, it should not matter if they reached that voltage...
  6. Replies
    62
    Views
    2,244

    I like the ingenuity very much. Do you think...

    I like the ingenuity very much. Do you think filling the bolt protectors with silicone, like caulk, and then placing them onto the lenses to let the silicone flow into the groove, would be a viable...
  7. Replies
    14
    Views
    200

    From an eBay seller's ad: "The EOS0730iNET3...

    From an eBay seller's ad:
    "The EOS0730iNET3 requires a 24V-29V power supply to make full use of the potential. At this input voltage the charger performs at a higher efficiency which allows for...
  8. Replies
    17
    Views
    216

    It indicates how many revolutions an unloaded...

    It indicates how many revolutions an unloaded motor will make per volt supplied. As an owner of two 7700kv motors, I can tell you that one doesn't belong in a Slash.
  9. Replies
    36
    Views
    462

    I set my ERBE's LVC and my LVA's at 3.5 volts per...

    I set my ERBE's LVC and my LVA's at 3.5 volts per cell and my SPC batteries are always at 3.8 to 3.9 volts per cell when I bring them into the house.
    I ran six packs between my Summit and ERBE a...
  10. Replies
    2
    Views
    34

    Traxxas EZ Peak Plus DC Power

    Also, converted PC or server power supplies, RV/boat battery charger/maintainers, purpose-built 12V power supplies from hundreds of sources...
  11. Replies
    4
    Views
    126

    Fwiw, you can do the "dip test" holding the quad...

    Fwiw, you can do the "dip test" holding the quad upside-down too.
  12. Replies
    2
    Views
    63

    The stock part number is 4949. This is for...

    The stock part number is 4949. This is for plastic shafts.
    You can continue the investigation by researching these 4949R CVDs.
  13. Thread: Convince me

    by ksb51rl
    Replies
    12
    Views
    240

    I have both blue and green. Orange and green are...

    I have both blue and green. Orange and green are IMO easiest to see. Luckily, for $10 (list price for lenses, rotors, and canopy) you can totally change to any of the other colors. And then you've...
  14. Thread: Convince me

    by ksb51rl
    Replies
    12
    Views
    240

    To make sure this does not devolve into a this vs...

    To make sure this does not devolve into a this vs that thread, let's concentrate on the LaTrax product, whatever your opinion of it may be. Thanks!
  15. Replies
    14
    Views
    235

    Battery 4x4 stampede vxl

    I'm not sure if it was formerly the case with LiPos in general, but there has been no recent proof, conclusive or otherwise, that faster charging with a decent charger carries a cycles penalty. You...
  16. Replies
    17
    Views
    209

    "They" do not.

    "They" do not.
  17. Replies
    16
    Views
    210

    E-Revo or Summit questions.

    The remote locking diffs, mostly. Yes, you can lock the diffs with putty or something else, but then you can't unlock them with the flip of a switch.
    There is only one receiver, with more channels...
  18. Replies
    16
    Views
    210

    I have both a Summit and E-Revos (BL) with...

    I have both a Summit and E-Revos (BL) with 2-speed transmissions. Comparing the two on a serious trail (see this post) is not very fair to the E-Revo. Then again, comparing the two in a flat, open...
  19. Replies
    4
    Views
    101

    e-maxx single motor

    I was wrong and you have my apologies for that. The Titan 775 has a bolt spacing of 29mm and the Castle 1515 and the 550 motors have a lot spacing of 25mm. I was fooled by the E-Revo's motor mount...
  20. Replies
    3
    Views
    116

    Probably should get new batteries.

    Probably should get new batteries.
  21. Thread: E-Maxx Motors

    by ksb51rl
    Replies
    4
    Views
    136

    Since the EVX-2 can handle a pair of...

    Since the EVX-2 can handle a pair of 20-something-turn 550 motors, I have no doubt 35T 540s will be within its capabilities. But why not look at a single Titan 775?
  22. Replies
    4
    Views
    101

    e-maxx single motor

    The Titan 775 has the same bolt spacing as the castle Creations 1515 motor in the EMBE. Therefor the 3997X motor plate used in the EMBE should work well for you.
    FWIW, the Dewalt 820 motors have a...
  23. Thread: my new emaxx

    by ksb51rl
    Replies
    8
    Views
    154

    It depends on the brushless system. I wouldn't...

    It depends on the brushless system. I wouldn't throw a Traxxas MXL-6Ss and 2200kv motor in there and run it on 6S, but there are other options.
    Slipper clutch! That's another area where the new...
  24. Thread: my new emaxx

    by ksb51rl
    Replies
    8
    Views
    154

    my new emaxx

    I'm not sure what the tires are, but most of the rest is original 3906 E- Maxx. It doesn't even have the wide-Maxx arms - I can see those are the original narrow arms.
    Some will say the EVX can...
  25. Replies
    4
    Views
    130

    clinical is correct, just in case you had a doubt.

    clinical is correct, just in case you had a doubt.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4