Search:

Type: Posts; User: L-banger

Search: Search took 0.17 seconds.

  1. Replies
    4
    Views
    250

    Thank you fellas for the helpful suggestions....

    Thank you fellas for the helpful suggestions. Will try to resolve the issue tomorrow. I'm much appreciative.
  2. Replies
    4
    Views
    250

    Spur gear and clutch bell meshing issue?

    Yesterday I replaced the factory stock (38 tooth) spur gear with a (36 tooth) gear. I stayed with the factory stock (14 tooth)clutch bell.I reinstalled the 3.3 onto my truck, and followed the gear...
  3. Thread: Engine swap

    by L-banger
    Replies
    2
    Views
    281

    Thanks for the advice Jersey Jato, much...

    Thanks for the advice Jersey Jato, much appreciated. I plan on upgrading the stock clutch with a Buku clutch. Does I need to upgrade the spur gear and the tranny also?
  4. Thread: Engine swap

    by L-banger
    Replies
    2
    Views
    281

    Engine swap

    I have the stock 3.3 engine with the R.O.A.R tuned pipe. I'm considering purchasing a LRP ZR.32 Spec.2 pull start engine.
    I also want to upgrade to a tuned pipe from Extreme RC Mods. According to...
  5. Replies
    3
    Views
    200

    Stock clutch components

    I recently disassembled the spur gear/clutch combination on my factory Revo 3.3. This is the first time that I have tinkered with anything involving the transmission. I noticed that a clutch spring...
  6. Replies
    7
    Views
    554

    *UPDATE* I did the hairdryer tip to pre-warm...

    *UPDATE* I did the hairdryer tip to pre-warm the engine before starting it. I allowed it to idle for a couple minutes and applied throttle more than previously. The truck moved on its own, thus...
  7. Replies
    7
    Views
    554

    Thanks for the advice fellas. I will try the...

    Thanks for the advice fellas. I will try the hairdryer tip. I'll post a video asap.
  8. Replies
    7
    Views
    554

    Truck won't move on it's own power

    I purchased a new Revo 3.3 on 7/12/12. I fully charged both of the supplied battery packs and installed new batteries in the Tx. I fueled the truck with 20% and had to reset the needles to factory...
Results 1 to 8 of 8