Search:

The reason I called it a summit was because I currently have a summit and a spare 3.3 motor therefore I will only need a few revo parts in order to make it work

Thanks b@3 thats exactly what I was looking for.

Has anyone here attempted converting their summit to nitro? Since it is based off the revo platform would everything match up to do it? I don't think it would take much more than the aluminum...

I am not worried about going 100mph with it, but if I undergear it do you think the temps can stay in a reasonable range?

So basically to save a few dollars you can buy a roller and use your electronics from the erbe and make sure to undergear it so the motor doesn't overheat and add a few capacitors to the esc and you...

Thanks for the quick replys.. What speeds can be expected with the 2200kv motor and MMM with the "100mph" gearing?

I have been looking around the threads and haven't seen if anyone has put the MMM from the erbe in the Xo-1. I think it could save people a few bucks if they buy the roller and drop the MMM...

is the body mount on top of the chassis? becasue the tab on the two front screws is supposeed to go in between the bulkhead and the chassis i had the same problem and realized my error

yes it is overkill but overkill gets you high speeds. i am hoping to run 45/45 by the end of the week, and yes it is a strain on the batteries so i have been limiting it to two runs per pack I will...

can i ask what motor esc, did you run 3s in parallel or a single battery, 50/31 isn't much of a speed gearing but I may be
wrong?

Well i got a few runs in today still waiting on the 45 tooth pinion from robinson racing. I ran the traxxas 3s batteries in parallel and got a top speed of 72 without the motor or esc getting hot. I...

no need to control it.. Ive got a 2000ft runway to go down plenty of room for mistakes.

hey thanks a lot i was off by around 5mph using the calculator except it doesnt put wind resistance into account but i have a
ballpark now.

okay I am trying to make a 100mph mini revo but I need to see if someone could check my math.. I have a mamba max pro with 5700kv motor I will be running two 2s lipos in series so it can support the...

I have the second gen (no temp sensor) VXL motor and esc.. not the castle one. I am using the stock nimh batteries and they work fine in my summit and revo so they batteries dont seem to be bad

Hey guys I recently purchased one of the spartan boats and was wondering if anyone can help me. When I plug in the batteries the esc does the three beeps and engages but when I hit the throttle...

I have one that I am looking to sell..Recently took the whole truck apart to clean it and has only been driven once since then.. How much are you looking to spend?

Thanks for the help.. I took apart the rear diff and a few of the teeth were rounded at the tip..looks like a new ring and pinion

Hello I seem to have a problem with my summit. When give it hard throttle there seems to be an initial clicking noise before the truck accelerates.. I cannot quite tell where it is coming from. If...

ive got summit wheels on
proline road rages

if the esc is blinking red and it wont bind it could be a bad steering servo.. that happened to me and traxxas sent me a new one.. if the receiver is blinking as stated above possible moisture in...

i have the same problem I get worried every time i run them.. hope you can get an answer

I was in the same predicament as you I was going to go with the 3500 but went with the 1/16 mount and plate with the castle sidewinder.. my advise is spend the extra money and not have to worry about...