Search:

Type: Posts; User: Revo_Xtream49

Page 1 of 5 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    27
    Views
    853

    Congrats to Steve on a well deserved win! ...

    Congrats to Steve on a well deserved win!



    On lap one of the race I broke off the whole body/wing mount so the body was only held on by the two front clips. The 93 second lap was my pitstop....
  2. Replies
    13
    Views
    604

    Or if you race it adds another failure point to...

    Or if you race it adds another failure point to the entire system, you can finish a race with a straight shaft. I have never liked a center diff in a MT, straight aluminum shaft is my pick in my...
  3. I am really bad with anything prebuilt. I have 3...

    I am really bad with anything prebuilt. I have 3 tray's and I take apart the front, center, and rear and put them on there own tray's. I then completely rebuild the vehicle. I do not trust anything...
  4. Replies
    16
    Views
    512

    I went with two 5990's hitec servos one for...

    I went with two 5990's hitec servos one for throttle and steering, so I can run Full Lipo with no regulator! Ok a little expensive, but man is it nice, a little bit overkill with 412oz for throttle...
  5. Replies
    20
    Views
    623

    I have tried many diffrent pipes and always seem...

    I have tried many diffrent pipes and always seem to go back to the dual chamber blue. Seems to keep the engines running cool and the engine still produces power.
  6. Replies
    10
    Views
    542

    The big thing with the titan is to follow the...

    The big thing with the titan is to follow the break in instructions in the manual and make sure your lube your bushings with some type of light oil so the bushings do not wear out.
  7. Replies
    10
    Views
    567

    I have been having the same problem with the...

    I have been having the same problem with the Robinson racing pinions, but my friend has been using the Team Losi pinions which fit the gear better and seems to last longer than stock traxxas and...
  8. Replies
    347
    Views
    12,974

    Well I should have the old Cowboy design of this...

    Well I should have the old Cowboy design of this at the Pro Series Finals with no rear brake setup. One of these days I am going to have to get a 3.3 chassis and try to do a rear brake setup on this...
  9. Replies
    15
    Views
    370

    I just did have to replace mine on my revo after...

    I just did have to replace mine on my revo after 4 years. Not because it broke though, the pin's where the rocker arm's go had hairline cracks going down the sides of them. I figured by that point...
  10. Replies
    13
    Views
    442

    We have a track here in town that normaly pulls...

    We have a track here in town that normaly pulls in 15-20 slashers a night with unlimited rules. Although for the last few weekends stock has taken the win!
  11. Replies
    50
    Views
    1,331

    179.00 Slash 160.00 2 Lipo's 6.00 Blue lock...

    179.00 Slash
    160.00 2 Lipo's
    6.00 Blue lock nuts
    345.00 Total
  12. Replies
    9
    Views
    608

    I am guessing that if you have tried the battery...

    I am guessing that if you have tried the battery pack swap that the slower truck will need a little bit more runtime and the engine will be broke in. I know mine took a couple packs of runtime before...
  13. Replies
    17
    Views
    948

    I like both bodies, but I am liking the Proline...

    I like both bodies, but I am liking the Proline one just a little bit better. The one thing I hate with the proline body is the light decals, the grill is so huge the lights do not look perpotional...
  14. Replies
    4
    Views
    468

    My favorite is putting a 20 tooth pinion on loose...

    My favorite is putting a 20 tooth pinion on loose tracks with the complete stock setup. It does not loop out as hard as with the 18tooth and gives you a little bit more top end. On a 30 min run with...
  15. Replies
    13
    Views
    865

    I called Traxxas a few weeks back to find out...

    I called Traxxas a few weeks back to find out what the stock oil was in it. The guy on the phone recommended 40wt all the way around. I have had great luck with running that so far.
  16. Smoke is always a good thing, on my big block...

    Smoke is always a good thing, on my big block engines are just tune till it smokes both top and bottom. My small block is a totally different beast and this is the way I will tune mine for race prep....
  17. Replies
    20
    Views
    883

    My setup that has worked everywhere and done...

    My setup that has worked everywhere and done quite a bit of winning with is

    40wt Losi Oil all the way around in the stock setup,

    Add 2mm spacers to the front and rear shocks

    Do a half a...
  18. Replies
    347
    Views
    12,974

    I was needing to know where the shims all went....

    I was needing to know where the shims all went. For some reason it feels like there is a lot of tention on the setup.
  19. Replies
    347
    Views
    12,974

    I am trying to reinstall my old diff and was...

    I am trying to reinstall my old diff and was wondering if anyone had a picture of the original diagram that cowboy sent out with his diffs. Thanks if you have it.
  20. Also at the auto parts store they have some QC...

    Also at the auto parts store they have some QC Electronic cleaner there for 4 bucks a can. I have used it on my Titan 12 and have over 14 hours of run time on it with no signs of stopping.
  21. Replies
    347
    Views
    12,974

    If someone figures out a rear shaft for the rear...

    If someone figures out a rear shaft for the rear brake setup on Cowboy Ray's setup, I still have one and tried to figure out how to custom make the shaft for the new Tranny case. What was the normal...
  22. Replies
    7
    Views
    332

    If you have a good throttle finger you will be...

    If you have a good throttle finger you will be faster without that center diff. The last center diff I tried in a 45 min main seemed to get hot about 20 min in and then it started unloading to the...
  23. Replies
    27
    Views
    556

    I actually raced one indoors for awhile, we took...

    I actually raced one indoors for awhile, we took a 2.5 chassis and bought some front ribbed tires and raced it indoors. It steered like a dream, but man it was loose as can be. I think we needed to...
  24. Replies
    7
    Views
    518

    19 turn would probably be the way to go. Most of...

    19 turn would probably be the way to go. Most of the 19 turns I have owned had a long life with proper care, you go with any less turns than that your in for a maintenance hog "Comm cutting and...
  25. Replies
    18
    Views
    956

    I have always bought race machines or bought...

    I have always bought race machines or bought machines to convert to race machines. The Slash is the first truck I have bought that I am going to keep completely stock because they are just a blast to...
Results 1 to 25 of 109
Page 1 of 5 1 2 3 4