Search:

Type: Posts; User: Goldorak

Search: Search took 0.11 seconds.

  1. Thread: 3s lipos

    by Goldorak
    Replies
    2
    Views
    401

    i run 3s since December , yesterday my ESC dies...

    i run 3s since December , yesterday my ESC dies dramatically....it simply go to full reverse at aver 30MPH with a very nice white smoke from the ESC , result , about 95 rollovers and 1 a-arm snap ,...
  2. Yes you can rebuild the original CVD just use...

    Yes you can rebuild the original CVD
    just use a 1/16 drill to drill out the broken pin and replace it with a 1/16x1/2 dowel pin
    I buy them from mcmaster carr

    but now im running the GPM steel...
  3. Replies
    17
    Views
    956

    +1 , who cares that a 8$ battery dosen't run 300...

    +1 , who cares that a 8$ battery dosen't run 300 cycles , you can get 5 of them for less than a single maxamps

    by far , no problems with my 1.5 3s ******* , even if i charge them at 2C
  4. Thread: Diff oil

    by Goldorak
    Replies
    14
    Views
    3,311

    http://www.youtube.com/watch?v=zkO-0zTQDhY ...

    http://www.youtube.com/watch?v=zkO-0zTQDhY

    this is a good one
  5. Thread: back flips??

    by Goldorak
    Replies
    2
    Views
    398

    just stiffen the rear suspension and put a 3s...

    just stiffen the rear suspension and put a 3s lipo and it will flip on command
  6. Replies
    66
    Views
    7,311

    ^this is my next mod, i was able to rebuild my...

    ^this is my next mod, i was able to rebuild my CVD's but it's a matter of time to destroy them again
  7. Replies
    7
    Views
    986

    turnigy 3s 1500mah they fit tight, i got to...

    ******* 3s 1500mah

    they fit tight, i got to cut the corner of the battery box to clear the wire

    but now my summit run like a rocket and flip on demand
  8. Replies
    7
    Views
    1,782

    i was able to repair mine ( i am a machinist) i...

    i was able to repair mine ( i am a machinist) i make a .137 diameter pin x 1/4lg and drilled a 1/16 cross hole and reassemble the CVD's with a 1/16 dowel pin (tempered locating pin) , i also put 1/2...
  9. Replies
    66
    Views
    7,311

    after stripping 4 shaft . im going to that route...

    after stripping 4 shaft . im going to that route too

    3s lipo deliver too much power for the stock CVD's
Results 1 to 9 of 9