Search:

Type: Posts; User: munted1972

Search: Search took 0.22 seconds.

  1. Replies
    18
    Views
    1,805

    Had the same problem with button getting stuck ,...

    Had the same problem with button getting stuck , opened the back of ESC and found the electronics are fully potted in place with clear goop . I used a small scalpel to go around where the button...
  2. Replies
    21
    Views
    1,894

    some products i've had great performance from are...

    some products i've had great performance from are Tamiya masking tape it comes in little rolls of 3mm to 12mm wide and is great for really fine line work and then mask out the rest with 3M Green...
  3. Replies
    6
    Views
    1,514

    "The Cat" looks a lot like a "grasshopper" analog...

    "The Cat" looks a lot like a "grasshopper" analog of which there have been many, I reckon there might have been some RTRs in the 80's I think AYK cars were pre assymbled ?
  4. Thread: e-4tec?

    by munted1972
    Replies
    2
    Views
    294

    The basic design of the original 4tec is quite...

    The basic design of the original 4tec is quite good although any new brushless version would certainly need to be made of stronger or more impact resistant material, I have a box full of busted...
  5. Replies
    4
    Views
    565

    The Fingertech robotics belt is about 4mm wide...

    The Fingertech robotics belt is about 4mm wide same as the front , I think all the S3M belts are the same width. I just replaced the stripped pulley with a new plastic one and have removed the...
  6. Replies
    4
    Views
    565

    Seems to hold up well ! I've been running a...

    Seems to hold up well ! I've been running a 5700kv Castle sidewinder with no slipper ,big battery & soft foams on a really high grip tennis court, the belt takes it but the 15t (p/n.4395) pulley has...
  7. Replies
    4
    Views
    565

    New rear Belt for 3.3 diff conversion

    I have found a rear Belt that fits E 4tec with 3.3 diffs fitted ,S3M 165mm (55T) .
    available from FingerTechRobotics.com for about $3 plus postage .
  8. Replies
    73
    Views
    20,555

    Sticky: I have found a supplier of S3M Belts that has a...

    I have found a supplier of S3M Belts that has a 55T / 165mm and a 57T / 171 mm and one of each on order , if either fits ok I will post details
Results 1 to 8 of 8