Search:

Type: Posts; User: BroncoDave

Search: Search took 0.03 seconds.

  1. Every time I thought I was finished with the...

    Every time I thought I was finished with the cage, it seemed I found more interferences. But here's the engine mount side after bending both the tube and the attach point:...
  2. Bomber, just for the record, you were right. I...

    Bomber, just for the record, you were right. I just started working on moving everything else over from the old chassis, and sure enough, the nerf bar does share an attach point with the roll bar. ...
  3. Yeah, I was really hoping to find an engine...

    Yeah, I was really hoping to find an engine (only) cage made by someone else but ... no dice.
  4. I bent the tab some, bent the tube some, bent the...

    I bent the tab some, bent the tube some, bent the tube some more, bent the tab a little more etc and it's pretty dang close. Pretty dang frustrating though too. I thought about a spacer, but then...
  5. Unfortunately, I'm limited to my hacksaw and...

    Unfortunately, I'm limited to my hacksaw and JBWeld as far as tools go, so I think at this point I'll see what I can do about bending it to match. I got the chassis from my lhs for $49 - then...
  6. Integy C22559 engine roll cage install issue

    So I landed my truck engine first a couple weeks back, and after attempting to straighten the chassis a couple times and spitting 3 slipper clutches off into the ether, I finally accepted the...
Results 1 to 6 of 6