Search:

Type: Posts; User: Sir Slide Alot

Search: Search took 0.23 seconds.

  1. Replies
    61
    Views
    6,359

    Any picture's of the RX8?

    Any picture's of the RX8?
  2. Number's 1515 means 1.5" stator diameter and 1.5"...

    Number's 1515 means 1.5" stator diameter and 1.5" stator lenght.

    no MM's in them used. nor magnet measurements.
  3. Replies
    61
    Views
    6,359

    Where does that picture come from?

    Where does that picture come from?
  4. Feigao does have a stator in their design, but it...

    Feigao does have a stator in their design, but it is made different the the usaul slotted design.

    It is basicly just washers againt each other and winding is inside them.
  5. Replies
    2
    Views
    417

    Does your shift servo move far enough? Do you...

    Does your shift servo move far enough?

    Do you shift like you are suppose to do?
  6. Replies
    10
    Views
    727

    If you use a single 775 from Mabuchi (Bane-Bots,...

    If you use a single 775 from Mabuchi (Bane-Bots, Graupner,...) it fit's right on the standard motor-mount, might get the single plate and single cover tough for good looks.

    The Titan 775 from the...
  7. That's what i needed to hear. Thanks George.:)

    That's what i needed to hear. Thanks George.:)
  8. E-revo Front Half-Shaft same as Nitro Revo?

    Hi all,

    I got a E-REVO on order and i would like to know if a Revo 2.5 or 3.3 front half-shaft is the same lenght as in the E to use a RD Racing Quick-Turn( one-way axle)?

    He has sets for the...
  9. Replies
    1
    Views
    318

    Make holes in the tire, way easier and water can...

    Make holes in the tire, way easier and water can get out. 3mm or 4mm should do.
  10. Replies
    23
    Views
    940

    Quite a bit of them broke, yes. they are...

    Quite a bit of them broke, yes.

    they are lookin for the solution.

    Plenty others out there, Kontronik and Quark being 2 of the best out there they really deserve some more attention.
  11. Tekno RC Neu has a flat spot shaft, bolted...

    Tekno RC Neu has a flat spot shaft, bolted endbell, bigger bearings, hand-wound and best of all; BLEU Anodized
  12. Replies
    32
    Views
    1,610

    If you use the reinforcementplate that come's...

    If you use the reinforcementplate that come's with the newer E-MAXX/E-REVO diffset the diff should lock more under braking then onpower.

    This would give you good brakes without disc brakes, yet...
  13. Replies
    15
    Views
    654

    A ex-boat motor is one thing i'd never buy...

    A ex-boat motor is one thing i'd never buy personally.
    Boats are really hard on electronics.


    And your best bet for good info (possible pricing) on rebuilding a 15 series Neu is to mail Steve...
  14. Replies
    17
    Views
    1,114

    Heat it with a solder iron, if it doesnt loosen...

    Heat it with a solder iron, if it doesnt loosen at 300C then i dont know.:fear:
  15. Replies
    26
    Views
    1,090

    Old MAXX wheels with pro-line badlands. ...

    Old MAXX wheels with pro-line badlands.

    Stumblin, i wish you the best of luck with the Monster Mamba.
  16. Replies
    1
    Views
    176

    Hyperion use Enerland cells as Flightpower does,...

    Hyperion use Enerland cells as Flightpower does, and the 5350 is very lazy.

    It only puts out 15c or so, wich is too low for cars and truck at that mah rating.

    look in the Hyperion VX and VZ...
  17. Replies
    22
    Views
    1,119

    I ran a original HV system for around 10 minutes...

    I ran a original HV system for around 10 minutes on the recommended ratio's, after that the motor had a burned true wire in the windings wich made it ready for the trash can.

    My last Novak, a 21.5...
  18. Replies
    18
    Views
    2,470

    I think you would not be able to have a nice...

    I think you would not be able to have a nice fitting body as this will add 30mm chassis width.

    Maybe we need a chassis that lets the packs go deeper in the center.
  19. Replies
    10
    Views
    643

    With the standard setup you use 2 channel's. ...

    With the standard setup you use 2 channel's.

    CH1 for steering, CH2 throttle.

    The stock RX has 2 CH1 outputs where both steering servo or plugged into.

    If you can mix the auxilary channel on...
  20. Replies
    14
    Views
    739

    No a E-Revo no, it has outboards shocks. Nice...

    No a E-Revo no, it has outboards shocks.

    Nice of them to work with plugs on the ESC.
Results 1 to 20 of 20