Search:

Type: Posts; User: clinical

Page 1 of 12 1 2 3 4

Search: Search took 0.18 seconds.

  1. You need to get into the receiver box to plug the...

    You need to get into the receiver box to plug the lights in - to do this you will need to remove the motor so that you can get to one of the screws that holds down the receiver box entry guard.
    Not...
  2. Replies
    15
    Views
    262

    As long as you tell me which bin you throw it in...

    As long as you tell me which bin you throw it in so I can come past and grab it out! :)
  3. Replies
    15
    Views
    262

    Did you go through the binding & calibration...

    Did you go through the binding & calibration steps properly?
  4. Replies
    9
    Views
    127

    You want the highest C rating you an get. Having...

    You want the highest C rating you an get. Having said that companies often lie about their C ratings.
    You want to try to make sure that the c rating multiplied by the amp capacity of the battery...
  5. Replies
    9
    Views
    127

    Most reposted ever :) ...

    Most reposted ever :)

    http://tapatalk.imageshack.com/v2/14/09/28/eab3e9632518a42297e3841adeb95678.jpg
  6. Thread: Diff Locks

    by clinical
    Replies
    8
    Views
    134

    But then you can't have just the front locked. ...

    But then you can't have just the front locked.

    I think the OP wants all options
    - both unlocked
    - front locked
    - rear locked
    - both locked
  7. Replies
    9
    Views
    127

    As for chargers - it depends what you want....

    As for chargers - it depends what you want. Hyperion make good chargers & I had have a Hitec X4 that I use a lot & rate highly. Are you thinking AC charger or using a power supply?
  8. Thread: Diff Locks

    by clinical
    Replies
    8
    Views
    134

    The diff locking switch has 3 positions. Both...

    The diff locking switch has 3 positions.
    Both unlocked
    Front locked
    Both front & rear locked

    You can not have just the rear locked with the stock set up.
  9. Replies
    9
    Views
    127

    Avoid the Traxxas charger and Lipos - not because...

    Avoid the Traxxas charger and Lipos - not because they are bad - in fact they are good! But because you can get better for cheaper!
    For lipos look at SPC or SMC lipos - just check out their...
  10. Replies
    24
    Views
    470

    If you want to stop them from popping out then...

    If you want to stop them from popping out then buy the extended drive cups. They are a few mm's longer and so the shafts don't pop out all the time.
  11. SMC 9400mah 2S Lipos are the business!

    SMC 9400mah 2S Lipos are the business!
  12. Replies
    21
    Views
    545

    Check out some of the dedicated losi diff mod...

    Check out some of the dedicated losi diff mod threads.

    http://traxxas.com/forums/showthread.php?8998953-LST2-diff-mod

    Essentially you have Dremel the bulkheads & diff cases to fit the losi...
  13. Replies
    21
    Views
    545

    Like I said in my first post above - everyone has...

    Like I said in my first post above - everyone has different opinions about just about every upgrade. Some like fans, some like double fans, some don't like any fans. Some like CVD's, others like MIP...
  14. Replies
    42
    Views
    1,288

    Mate I am keen to try it - where abouts in...

    Mate I am keen to try it - where abouts in Australia are ya?
  15. Replies
    21
    Views
    545

    full upgraded e revo

    So many upgrades are subjective & what one person tells you will be different to another persons opinion.
    My Erevo is pretty much 'fully upgraded' so I'll give you my list of upgrades.

    HPP hexes...
  16. Replies
    6
    Views
    151

    ^^ what he said - not unless you are going to...

    ^^ what he said - not unless you are going to race it on the track.
    As for lipos - you need 2
  17. Replies
    6
    Views
    243

    Sounds like you have done a few upgrades but also...

    Sounds like you have done a few upgrades but also sounds like you need to install sway bars.
    Whilst you had it torn down you should have dyed the chassis & rockers.
    Glad you're enjoying it.
  18. Thread: Problems

    by clinical
    Replies
    11
    Views
    165

    I am guessing by 2s you mean 2x2S which is...

    I am guessing by 2s you mean 2x2S which is actually 4S?
  19. Thread: Problems

    by clinical
    Replies
    11
    Views
    165

    Check the steering servos - a failing servo can...

    Check the steering servos - a failing servo can cause all kinds of weird faults.
  20. Thread: Problems

    by clinical
    Replies
    11
    Views
    165

    Replace the batteries in the transmitter.

    Replace the batteries in the transmitter.
  21. Replies
    32
    Views
    430

    ^^ what he said!

    ^^ what he said!
  22. Replies
    18
    Views
    594

    I did it. How? I followed a bunch of threads &...

    I did it. How? I followed a bunch of threads & asked ^^this guy a heap of questions!
  23. Replies
    17
    Views
    345

    Sell it!!!

    Sell it!!!
  24. I run the Sensored HW and it is awesome - love it!

    I run the Sensored HW and it is awesome - love it!
  25. Replies
    16
    Views
    507

    Don't get me wrong - it is quite an involved...

    Don't get me wrong - it is quite an involved process and I was exactly the same before I did it - I was worried and didn't know if I should take it on or not. But there are a bunch of GREAT threads...
Results 1 to 25 of 288
Page 1 of 12 1 2 3 4