Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.59 seconds.

  1. Replies
    1
    Views
    47

    It's the grease of the gears mixing with the...

    It's the grease of the gears mixing with the little fuel seeping out past the starter shaft. Just wipe off to clean. Nothing to worry about.
  2. Thread: Splitter

    by Double G
    Replies
    4
    Views
    57

    http://traxxas.com/forums/showthread.php?9010526-9...

    http://traxxas.com/forums/showthread.php?9010526-9010526&p=5739691#post5739691
  3. Replies
    6
    Views
    107

    Go to the Traxxas 2070/2075 servo or stronger and...

    Go to the Traxxas 2070/2075 servo or stronger and make sure that the whole steering system moves freely with no binding.
  4. Thread: free revo

    by Double G
    Replies
    13
    Views
    321

    I see you've mentioned this a few times before. ...

    I see you've mentioned this a few times before. Do not doubt you. However, I have been able to make the carb fit with the stock arm. I've ground down the arm on the carb to make it fit. Even...
  5. Replies
    1
    Views
    31

    To my knowledge the speed is calculated based...

    To my knowledge the speed is calculated based upon the engine rpms so even at a stop it will show that it is moving. You could get a speed gun and test and either calibrate through the ipod/iphone...
  6. Replies
    4
    Views
    126

    If you find that you need to give it a lot more...

    If you find that you need to give it a lot more throttle just to hover and flight is starting to get erratic, hold the chopper by the body and tilt it down at each corner. The motor(s) that does not...
  7. True true. When I first started with nitro I read...

    True true. When I first started with nitro I read up on other forums and saw on YouTube how to do this. I used RTV all over and it didn't help. I thought I had an air leak but turned out I needed...
  8. Lock second gear by using screws.

    Lock second gear by using screws.
  9. Clean/rebuild every fall before putting away for...

    Clean/rebuild every fall before putting away for winter.
  10. Thread: Pinion

    by Double G
    Replies
    1
    Views
    43

    No need for multiple threads asking the same...

    No need for multiple threads asking the same question.
    http://traxxas.com/forums/showthread.php?9010030-Unlocking
  11. Mine lasted for six years but that was with...

    Mine lasted for six years but that was with frequent cycling of the battery. It would have gone longer, however, I noted that it didn't have the run times as it used to and the power wasn't there. ...
  12. Replies
    11
    Views
    224

    First off, welcome to the forums. Secondly,...

    First off, welcome to the forums. Secondly, proper punctuation would help as it took me three tries to read the initial post to ascertain the issue.
    If it ran perfect for two tanks and then...
  13. Thread: free revo

    by Double G
    Replies
    13
    Views
    321

    It wasn't perfect tune, it was wide-open throttle...

    It wasn't perfect tune, it was wide-open throttle with no carb. I've done it to test a used engine to see if it runs, but still wouldn't recommend it.
  14. Thread: Remote start

    by Double G
    Replies
    2
    Views
    61

    FYI, 2-speed does not use channel 3, reverse...

    FYI, 2-speed does not use channel 3, reverse does. If you do not have reverse you can use 3 and don't need to buy a 4 channel radio.
  15. Thread: 3.3 stalling

    by Double G
    Replies
    4
    Views
    103

    Does it restart when cold? If so, the engine has...

    Does it restart when cold? If so, the engine has lost its pinch so time for a new engine or rebuild.
  16. Answers are in the Revo section. No need for the...

    Answers are in the Revo section. No need for the same question in two places.
  17. Thread: 2.5r to 3.3

    by Double G
    Replies
    4
    Views
    85

    Nothing .

    Nothing .
  18. You'll see one gear on the output shaft: ...

    You'll see one gear on the output shaft:
    http://buy.traxxas.com/images/products/5394X.jpg

    With reverse you'll see this:
    http://buy.traxxas.com/images/products/5395X.jpg
  19. Replies
    51
    Views
    1,140

    Surprised no one said anything in response to...

    Surprised no one said anything in response to this. The cut-out on the piston needs to face the carb. Remove the header and spin the engine and if you see the rod the piston is in backwards. IF...
  20. Replies
    31
    Views
    595

    This has moved to non-Traxxas discussion.

    This has moved to non-Traxxas discussion.
  21. Replies
    16
    Views
    276

    Best to contact Traxxas and see if they are able...

    Best to contact Traxxas and see if they are able to track serial numbers. Unlike an auto VIN, to the general public there is no resource to decipher serial numbers to verify what it belongs to. I...
  22. Replies
    1
    Views
    119

    No need for multiple threads regarding unlocking....

    No need for multiple threads regarding unlocking. Group your questions.
  23. Replies
    3
    Views
    97

    Yep. Inspect the starter shaft to make sure that...

    Yep. Inspect the starter shaft to make sure that it is not worn either.
  24. Replies
    9
    Views
    137

    Go to the Support tab above and click on the ERBE...

    Go to the Support tab above and click on the ERBE section and you'll get the exploded views.
  25. Thread: ez peak plus

    by Double G
    Replies
    2
    Views
    57

    Battery is probably dead. Have a multi-meter to...

    Battery is probably dead. Have a multi-meter to determine the voltage of the battery? It may be best to send it off to the recyclers.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4