Search:

Type: Posts; User: brandon980120

Search: Search took 0.11 seconds.

  1. Replies
    7
    Views
    529

    Do the 5 cell 6volt hump battery packs fit in the...

    Do the 5 cell 6volt hump battery packs fit in the stock battery box?
  2. Replies
    7
    Views
    529

    TQi/servo

    I partially followed one of your guys advice to another poster to upgrade to the 2.4 system and digital servos. I purchased the TQi 2.4ghz system & #2075 digital servo for steering but I did not...
  3. Replies
    0
    Views
    235

    TQi/servo

    I have an older Rustler that I upgraded to a 2.4ghz TQi rx/tx system and it worked fine until I upgraded the steering servo to #2075 Digital servo and now the rx is flashing red indicating low...
  4. Replies
    8
    Views
    473

    Will the ez start on my current .15 bolt right...

    Will the ez start on my current .15 bolt right into and work with the 2.5?
  5. Replies
    8
    Views
    473

    Ok so my next question would be is there anything...

    Ok so my next question would be is there anything other than the upgrade kit needed when going from the .15 to the 2.5? Obviously that is all I should "need" but in your guys experiences is there...
  6. Replies
    8
    Views
    473

    Need a little engine schoolin'!!!

    So now that I'm getting this Rustler figured out I'm starting to look for more power but I'm a little confused on the engine(s) that traxxas puts out. Is what is referred to as the TRX .15 the same...
  7. Replies
    32
    Views
    1,068

    Just out of curiosity what kind of lifespan is...

    Just out of curiosity what kind of lifespan is expected of these engines? I'm about 98% sure mine has the .15 in it and I can't decide if I want to get a tuned pipe since mine has exhaust coming off...
  8. Replies
    32
    Views
    1,068

    Oh don't take that post the wrong way I'm not...

    Oh don't take that post the wrong way I'm not going anywhere!!!! But I think I've got the basics figured out thanks to you guys... I'll absolutely be surfing this site regularly and driving my r/c...
  9. Replies
    32
    Views
    1,068

    Alright I think I'm starting to get this figured...

    Alright I think I'm starting to get this figured out!! Definitely not ready for any 2 speed tranny conversions I had just read somewhere on here that 2 speed trannys were available but wasn't sure if...
  10. Replies
    32
    Views
    1,068

    Haha only stupid questions around here are...

    Haha only stupid questions around here are mine!!! But to answer your question no I'm honestly not entirely sure I am adjusting the correct needle however I took the throttle and brake linkage apart...
  11. Replies
    32
    Views
    1,068

    Hate to keep being a bother but you guy have been...

    Hate to keep being a bother but you guy have been so helpful I can't stop asking!!! My next situation is that I can't tune the idle because the screw does seem to do anything to the gap? I've been...
  12. Replies
    32
    Views
    1,068

    Thanks for all of the quick responses!!! I did...

    Thanks for all of the quick responses!!! I did some adjusting on the needles and was able to get it running and was also able to drive a full tank of fuel through it!!! However I am noticing that...
  13. Replies
    32
    Views
    1,068

    New guy needs help!!!

    I have a used Nitro Rustler with what I believe is the .15 engine (not sure) it also has the EZ start and I'm having problems keeping it running. Ive been holding my finger on the exhaust to prime...
Results 1 to 13 of 13