Search:

Type: Posts; User: SplatInc

Page 1 of 2 1 2

Search: Search took 0.04 seconds.

  1. Replies
    17
    Views
    448

    Summit, it does everything the MERV can never...

    Summit, it does everything the MERV can never do(but slower).
  2. Replies
    15
    Views
    453

    Just the grumpy old man who runs the LHS

    Just the grumpy old man who runs the LHS
  3. Replies
    15
    Views
    453

    I have a summit as well which means that I will...

    I have a summit as well which means that I will want to upgrade to a 4 channel so I can consolidate to just 1 tx. :cool:
    I did pull the servo from the rx and it still glitched the throttle so I am...
  4. Replies
    15
    Views
    453

    I was hoping to avoid spending money on a new...

    I was hoping to avoid spending money on a new rx/tx combo
  5. Replies
    15
    Views
    453

    Yes, I meant AM receiver. I reprogrammed the...

    Yes, I meant AM receiver.
    I reprogrammed the ESC today and no-joy. Same glitching as before with the truck and tx only inches apart.
    I haven't tried the truck anywhere else for fear of it going...
  6. Replies
    15
    Views
    453

    FM receiver glitching

    My MERV is stock.
    I notice that when I am driving it in the road my car will suddenly swerve for no reason. The other day the car was cruising along at 1-2mph even after I adjusted the throttle...
  7. Replies
    4
    Views
    456

    Check your steering servo connection to your...

    Check your steering servo connection to your receiver. When my servo glitched out it affected my MERV in much the same way. Traxxas wanted me to send the whole unit in for inspection (thank god for...
  8. Sticky: Here is my MERV haulin but in the street... ...

    Here is my MERV haulin but in the street...

    http://www.youtube.com/watch?v=UtEGIjw6HvY
  9. Replies
    2
    Views
    362

    How about just the ESC and Motor?

    How about just the ESC and Motor?
  10. Replies
    17
    Views
    516

    Does anyone have a picture? Where exactly do I...

    Does anyone have a picture? Where exactly do I solder in the resistor?

    7 circuits of 1 light and a 150 ohm resistor = bright lights and no burn out?

    I know I don't have 7 extra spaces on my...
  11. Replies
    17
    Views
    516

    ok, because I am slow... 3 sets of 2 light...

    ok, because I am slow...
    3 sets of 2 light running into one of those red plug, then a y harness into the regular front lighting red connector.
    led's should be 5mm or less and 3W or more each....
  12. Replies
    17
    Views
    516

    I like the strap on lights but wanted diy if...

    I like the strap on lights but wanted diy if possible.

    For the 4.8mm lights. Should I have anything else in the circuit? Resistor, transistor, thermometer?

    Can I make two circuits of 3 lights...
  13. Replies
    17
    Views
    516

    Any suggestions on how to add more led's?

    I was looking at the front bumper and noticed there are 7 holes that would be perfect for more led's.
    What are the best lights to use and where to find them? Radio Shack?
    How should I power them?...
  14. Replies
    46
    Views
    4,005

    +1 on the teflon washers. Tried it out and it...

    +1 on the teflon washers.

    Tried it out and it takes out the slop. $1.25, it's a mod priced to move...
  15. Replies
    15
    Views
    1,142

    +1 Summit go anywhere....

    +1 Summit
    go anywhere....
  16. Replies
    16
    Views
    901

    I take my stock merv over to the golf course and...

    I take my stock merv over to the golf course and run it on the fairway. It will run through the rough but it's not fun.
    Big jumps into the bunkers are fun. Bone stock with SMC 2 cell and never had...
  17. Replies
    4
    Views
    544

    I replaced the bearing and that seems to have...

    I replaced the bearing and that seems to have fixed it. Ran the truck in low and high, no clicking or squealing. I am going to listen closely for any new sounds but I don't think I have to open the...
  18. Replies
    4
    Views
    544

    The pin is present and accounted for.:D 5 more...

    The pin is present and accounted for.:D
    5 more hours...
    4 yr old, temp down. Keeping medicated and hydrated...:unsure:
  19. Replies
    4
    Views
    544

    Transmission or slipper clutch broken?

    Was out practicing my "dukes of hazard' jumps at the bmx track and broke my truck. Go figure.
    After the last jump/crash it came down right side up but wouldn't move. It made some "I'm busted" noises...
  20. Replies
    6
    Views
    638

    Proline Helios Body. Spraycan paintjob....

    Proline Helios Body.
    Spraycan paintjob.
    http://www.youtube.com/watch?v=b0wOp0vgQ0s
  21. Replies
    8
    Views
    546

    I have both and think it's a matter of apples and...

    I have both and think it's a matter of apples and oranges. Since I have a MERV I don't have to go brushless on my summit :cool:
  22. Sticky: http://www.youtube.com/watch?v=b0wOp0vgQ0s ...

    http://www.youtube.com/watch?v=b0wOp0vgQ0s

    Starts off with my summit and ends on my MERV.

    Everything stock excepting the bodies.

    thats why we practice...
  23. Replies
    1
    Views
    265

    Jump, crash, repeat

    http://www.youtube.com/watch?v=b0wOp0vgQ0s

    Starts off with my summit and ends on my MERV.

    thats why we practice...
  24. Replies
    9
    Views
    517

    How much brighter are the LED's when modded like...

    How much brighter are the LED's when modded like that? Any comparison pics?
  25. Do I have do break in a replacement titan 775?

    Title says it all.
    Since I bought a replacement Titan 775 engine should I break it in before installing it? What advice is there for proper break in?
Results 1 to 25 of 38
Page 1 of 2 1 2