Search:

Type: Posts; User: Pangit1

Page 1 of 8 1 2 3 4

Search: Search took 0.19 seconds.

  1. Replies
    5
    Views
    415

    A T-Maxx tank will fit, all you have to do is cut...

    A T-Maxx tank will fit, all you have to do is cut out some of the reciver box "relocate the reciver to the middle batt tray." and wala you have a 125 cc tank
  2. Thread: Slippage Help

    by Pangit1
    Replies
    4
    Views
    251

    you could also add a heavier Diff oil to help...

    you could also add a heavier Diff oil to help prevent the engine from unloading on 1 tire causing it to spin
  3. Thread: Best Way To...

    by Pangit1
    Replies
    7
    Views
    271

    boil them for 5 to 10 min or put them in the oven...

    boil them for 5 to 10 min or put them in the oven at about 250-275 for same time. the heat will losen the glue.
  4. Replies
    5
    Views
    410

    You have to remember that JATO75 is useing a...

    You have to remember that JATO75 is useing a modded 3.3 w/ a duel chamber resonator pipe and a lightened chassis, so the results that we get will not be the same as his unless you set up like his. To...
  5. Replies
    68
    Views
    981

    also he keeps saying that his HSN is tight....if...

    also he keeps saying that his HSN is tight....if its tightened all the way, then it would be closed and not allow fuel into the engine. Make sure that the HSN is loose 4 turns from tight.
  6. Replies
    35
    Views
    1,088

    You might want to have em move that section of...

    You might want to have em move that section of fence that is on the track, that could really effect your lap times....lol JK Good luck on Sunday
  7. Thread: need help

    by Pangit1
    Replies
    13
    Views
    317

    I just had the same exact thing happen to me, Its...

    I just had the same exact thing happen to me, Its the glow plug, change it. It is not completely burnt out but does not have the ability to stay hot enough to run the engine unless you have the E-Z...
  8. Replies
    17
    Views
    490

    only in the rear batt compartment, they wont fint...

    only in the rear batt compartment, they wont fint in the middle compartment. they make a 5 cell flat pack that will fit in either. Check out the accessories for the jato on traxxas's home page
  9. Replies
    3
    Views
    270

    to help keep running when its on it's lid is the...

    to help keep running when its on it's lid is the only reason I could think of
  10. Replies
    17
    Views
    796

    so when is the "How to" and the parts list...

    so when is the "How to" and the parts list comming out?
  11. Thread: shiftin...

    by Pangit1
    Replies
    9
    Views
    307

    then it will depend on how you have it tuned and...

    then it will depend on how you have it tuned and how tight your slipper is, its going to very from car to car, but I think mine shifts between 35 and 45 don't know exactly. Something new for me to...
  12. Thread: shiftin...

    by Pangit1
    Replies
    9
    Views
    307

    the speed it shifts at is determined by where you...

    the speed it shifts at is determined by where you have you shift point set to... in other words the speeds will vary..
  13. Replies
    8
    Views
    322

    This place might have some ...

    This place might have some

    http://www.maximizerproducts.com/
  14. Replies
    11
    Views
    418

    could have a bad OW bearing

    could have a bad OW bearing
  15. Replies
    26
    Views
    1,127

    I know Nola just thought I'd give ya a hard time...

    I know Nola just thought I'd give ya a hard time :p
  16. Replies
    26
    Views
    1,127

    Hey Nola 2/4 = 1/2 lol, And Steve your not...

    Hey Nola 2/4 = 1/2 lol,

    And Steve your not going to get the best out of your car unless you learn how to tune it yourself, the tune will change nearly daily, minor changes primarily to the HSN to...
  17. Replies
    8
    Views
    504

    Man thats about 20 to 25 feet!......What broke??...

    Man thats about 20 to 25 feet!......What broke?? LOL
  18. Thread: throttle help!

    by Pangit1
    Replies
    16
    Views
    316

    this has happend to me twice.. The servo is bad.....

    this has happend to me twice.. The servo is bad.. If you are going to replace it you should up grade
  19. Thread: engine temp.

    by Pangit1
    Replies
    8
    Views
    309

    How is it performing if it is sluggish try...

    How is it performing if it is sluggish try leaning it up a bit. this should get you going faster and will raise your temps. Just besure not to excede around 260-270. Also ensure you keep it blowing...
  20. Replies
    5
    Views
    214

    front or back tower? if the back try putting on...

    front or back tower? if the back try putting on the wing kit thst New Era offers. this will take the impact and help prevent breaking the tower.
  21. Replies
    10
    Views
    574

    The Jato comes set up for a 5 cell rechargable...

    The Jato comes set up for a 5 cell rechargable pack, it even has a power lead that is in the receiver compartment that you need to pull out from the bottom of the receiver box and put into the slot...
  22. Replies
    10
    Views
    336

    so if I put that pipe on my 3.3 it should go 100+...

    so if I put that pipe on my 3.3 it should go 100+ right???? :wacko: :D
  23. Thread: Rossi

    by Pangit1
    Replies
    8
    Views
    257

    I thought the same thing so I checked around and...

    I thought the same thing so I checked around and it looks like standard wording that everyone posts with this engine. I think what they mean by "new" is that the are newly redesigned

    ...
  24. Thread: Rossi

    by Pangit1
    Replies
    8
    Views
    257

    I looked at the Hi-hobby web site and they were...

    I looked at the Hi-hobby web site and they were on there for 249.99, thats about a 70$ diff before shipping, thats about the same price that I saw anywhere else for the same engine "249" so I'm...
  25. Thread: removing tires

    by Pangit1
    Replies
    13
    Views
    341

    and then use an exacto knife to finish getting...

    and then use an exacto knife to finish getting them off the rim
Results 1 to 25 of 197
Page 1 of 8 1 2 3 4