Search:

Type: Posts; User: Qtop

Page 1 of 2 1 2

Search: Search took 0.34 seconds.

  1. Replies
    21
    Views
    1,068

    Same here... I do need to say that issues with...

    Same here... I do need to say that issues with pillow balls that pop out is because they dont use the metal black rings that are on the stock carriers.
    It is not mentioned in the rpm manual, but you...
  2. I wonder if it is possible to get the actual esc...

    I wonder if it is possible to get the actual esc temp without using the motor temp sensor for it.
  3. Maybe a stupid question.. Is shimming also needed...

    Maybe a stupid question.. Is shimming also needed with hot racing alloy diff cups?
  4. Replies
    27
    Views
    857

    Castle usb link....

    Castle usb link....
  5. Thread: Rpm wheel wobble

    by Qtop
    Replies
    9
    Views
    740

    Are your oversized bearings a tight fit in the...

    Are your oversized bearings a tight fit in the carriers?
  6. Thread: Rpm wheel wobble

    by Qtop
    Replies
    9
    Views
    740

    Maybe I should get regular rpm arms for the rear....

    Maybe I should get regular rpm arms for the rear. I think it is possible to use different carriers then.
  7. Thread: Rpm wheel wobble

    by Qtop
    Replies
    9
    Views
    740

    Sorry forgot to say that I use traxxas steel...

    Sorry forgot to say that I use traxxas steel cvd's. Hex is a tight fit. Measured all the big bearings. They are ok. Now one carrier hole for the big bearing is 0.4mm bigger then the other 3. And that...
  8. Thread: Rpm wheel wobble

    by Qtop
    Replies
    9
    Views
    740

    Rpm wheel wobble

    Just installed a rpm set including true track. Now one of the big bearings on the inside falls out if I turn it around, while the rest needed to be pressed in. Now I have a lot of wobble on one...
  9. Thread: Lipos

    by Qtop
    Replies
    15
    Views
    792

    Or 6s and limit the esc with the cc link cable....

    Or 6s and limit the esc with the cc link cable. Then you can always tune it up for speed runs.
    I got more then 6 hours of hard bashing with mine and still holding up.


    6s (two 3s 5000mAh 40-80C...
  10. Thread: 54t spur fit?

    by Qtop
    Replies
    36
    Views
    2,150

    I got the 5608L. I installed the telemetry...

    I got the 5608L. I installed the telemetry myself. The problem started when I mounted the 54t spur (with the numbers out)
    The gear cover that came with it was sensor ready. Now I found my problem...
  11. Thread: 54t spur fit?

    by Qtop
    Replies
    36
    Views
    2,150

    No my motor doesn't rub at all.

    No my motor doesn't rub at all.
  12. Thread: 54t spur fit?

    by Qtop
    Replies
    36
    Views
    2,150

    Same problem with my gear cover using the 54...

    Same problem with my gear cover using the 54 spur. I noticed some black scrapings after a run. After reassembling the slipper clutch and the gear cover the problem was gone. Still no clue what caused...
  13. Thread: Double's ERBE

    by Qtop
    Replies
    16
    Views
    763

    Let us know if one of your drive shafts pops out...

    Let us know if one of your drive shafts pops out because of the RPM true tracks and steel cvd´s combo. (if you go offroad)
  14. Replies
    501
    Views
    282,061

    Sticky: My ERBE

    http://billeder.rcgalleri.dk/galleri/fuldskaerm/470717-bil-traxxas-e-revo-dodge-charger
    http://billeder.rcgalleri.dk/galleri/fuldskaerm/470718-bil-traxxas-e-revo-dodge-charger...
  15. Replies
    3
    Views
    584

    New firmware 1.39 MMM

    Are there some people out there who use the latest firmware on there Mamba Monster Max?
    Good or bad experiences?

    Thanks
  16. Replies
    47
    Views
    3,591

    Because my new erbe burned after 5 min of use. So...

    Because my new erbe burned after 5 min of use. So I need to know if there is something I can do so it won't happen again with the new one I am getting.
  17. Replies
    47
    Views
    3,591

    Ok thanks. Maybe instead of a CC Bec it better to...

    Ok thanks. Maybe instead of a CC Bec it better to install a CC cap pack?
  18. Replies
    47
    Views
    3,591

    I just ordered a cc bec 10a for my MMM. Do I need...

    I just ordered a cc bec 10a for my MMM. Do I need to connect it directly on the esc power cables if I am running 2 3s packs?
    Or just on one pack so it will use only 11,1 volts?
    I know the bec can...
  19. Replies
    33
    Views
    1,551

    Yes the car was send back as they requested. I am...

    Yes the car was send back as they requested. I am living in Denmark and bought the car in Germany. I am Dutch. Just moved to a better country ��
  20. Replies
    33
    Views
    1,551

    Just recieved a email from the LHS that they are...

    Just recieved a email from the LHS that they are sending the car to Traxxas europe distributor.
    This can take as long as 6 weeks.
    As I used the car for no more then 5 minuts I want to claim a full...
  21. Replies
    21
    Views
    779

    My heart broke after the esc burned on the first...

    My heart broke after the esc burned on the first run of the car.........
  22. Replies
    33
    Views
    1,551

    Yes I just recieved my Castle link. 18/54 is the...

    Yes I just recieved my Castle link. 18/54 is the gear I will use. Any detune numbers for advise?
    I also ordered a MM2 just in case it happens again.
  23. Replies
    33
    Views
    1,551

    Well I got news from my LHS. They are sending it...

    Well I got news from my LHS. They are sending it to the European distributor and they will send a new one. So it does not go to the US. Still it will take some time to get back to Denmark.

    I kind...
  24. Replies
    33
    Views
    1,551

    If I only had a chance to brake with it.... never...

    If I only had a chance to brake with it.... never got to that.
  25. Replies
    33
    Views
    1,551

    Well before I got a chance to change the gearing,...

    Well before I got a chance to change the gearing, the esc went up in smoke on the first run. Just pulling up the road with minor trottle and boom...gone.
    First the esc started to make weird sounds...
Results 1 to 25 of 27
Page 1 of 2 1 2