Search:

Type: Posts; User: TheROOSTER

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    254

    Here you go....

    Here you go. http://traxxas.com/forums/showthread.php?t=8947646
  2. Replies
    67
    Views
    7,315

    It may just be the type of rock I run on but the...

    It may just be the type of rock I run on but the M3 and G8 seem too soft. In a sense that the lugs fold over or conform too good to where they don't grab on to edges or points.

    Compared to stock...
  3. Replies
    67
    Views
    7,315

    Thanks! Yea, the bumper just doesn't look right...

    Thanks! Yea, the bumper just doesn't look right sticking up over the hood hahaha.

    My tires are M2 compound which I personally prefer over the M3 and G8 compounds for rock work.
  4. Replies
    67
    Views
    7,315

    Got to try these out on the rocks today. I am...

    Got to try these out on the rocks today. I am very pleased. They have all the benefits of the stockers except without the ripping and the ballooning at high speeds. My only complaint is the offset of...
  5. Replies
    16
    Views
    492

    I had the same problem with glitching when the...

    I had the same problem with glitching when the truck was coming toward me or far away. I lengthened the antenna tube about 2 inches so that I could pull out the slack of the antenna wire that was...
  6. That's a good idea. It might not shift as good...

    That's a good idea. It might not shift as good though. With the tabs cut, the drum has 4 chances to engage. With the spokes cut, it only has 1. Would probably be a little stronger though. The 2 wide...
  7. I have been running it like this for months with...

    I have been running it like this for months with no problems. Been running a 25turn motor on 3 cell and my truck weighs about 8 lbs. It still shifts just as smooth as before the mod too. I don't know...
  8. Mine does the same thing. When I'm driving...

    Mine does the same thing. When I'm driving towards myself and when the left side of the truck is facing me(when the motor is between me and the antenna). I have a single Dewalt 14.4 and the old EVX...
  9. This is how it should look assembled correctly....

    This is how it should look assembled correctly. Notice the size difference in the tabs on the low gear side versus the high gear side.
    ...
  10. Those of you that use a Summit trans in crawlers might like this

    Here's a mod to remove most of the slop in the Summit trans.

    Those of you that use them in your SCX-10's and other crawlers know that the worst thing about the trans is when you transition from...
  11. Replies
    3
    Views
    698

    Tip to make the Summit crawl better

    If you want your Summit to crawl better and have more throttle control, change the throttle trigger switch on your transmitter to be 70/30 instead of 50/50 and then recalibrate the ESC. I did this to...
Results 1 to 11 of 11